Mitsubishi Electric PLK-E Serie Manual Básico página 145

M-308 [Message] FLOPPY DISK IS NOT INSERTED
M-309 [Message] THERE IS NO PATTERN DATA
M-310 [Message] FINISHED READ PLEASE TURN OFF POWER SUPPLY
M-311 [Message] THE TABLE FILE IS BEING READ
M-312 [Message] THE STEP FILE IS BEING READ
M-313 [Message] THE CLEARNESS AT THE MULTIPLICATION TIME ENDED.
M-314 [Message] THE TABLE NUMBER OF THE COPY AHEAD IS BEING USED NOW.
M-315 [Message] MAY I COPY THE SPECIFIED PATTERN DATA?
DEL
M-316 [Message] MAY I COPY ALL THE PATTERN DATA?
DEL
M-317 [Message] MAY I OVERWRITE THE COMBINATION DATA?
M-318 [Message] MAY I CLEAR PATTERN DATA OF COMBINATION DATA?
M-319 [Message] milling cutter is in lower position in this sewing data
M-320 [Message] Setting has been chaned. Please turn the power off
[Sub Message] PLEASE INSERT THE FLOPPY DISK.
[Sub Message] PLEASE INSERT THE FLOPPY DISK WHICH READ FILE ENTERED.
[Sub Message] RECLOSING OF POWER SUPPLY IS NECESSARY TO USE
CONTINUOUSLY.
[Sub Message] PLEASE WAIT FOR A WHILE
[Sub Message] PLEASE WAIT FOR A WHILE
[Sub Message] OVERWRITES SETTING
[Sub Message] OVERWRITES,THERE'S PAT DATA OF SAME No., FORMER DATA IS
[Sub Message] OVERWRITES,THERE'S PAT DATA OF SAME No., FORMER DATA IS
[Sub Message] FORMER DATA IS DELETED WHEN OVERWRITING.
[Sub Message]
[Sub Message] Please return to home position after the milling cutter goes up.
[Sub Message]
142