Mode "Battery powered"
In the mode "Battery powered", the pump is immediately activated and the LED lighting switches on when it is suffi-
ciently dark. The switch-on time is programmable.
Programming the switch-on time:
• Switch on the unit and switch from "Solar powered" to "Battery powered".
– The switch-on time is programmed. The unit will now switch to the mode "Battery powered" at the programmed
time every day. The unit switches off after approx. 4 hours. The operating time of the pump and LED lighting de-
pends on the battery capacity.
• To switch on the pump and LED lighting again, deactivate the mode "Battery powered" and activate it again.
Mode "Solar powered"
In the mode "Solar powered", the pump is powered by the solar module. Any surplus power is used for charging the
rechargeable battery. The mode can only be activated manually.
• Activating the mode "Solar powered": Switch on the unit.
– Activate the mode during sunny weather to charge the rechargeable battery.
Remedy of faults
Malfunction
The pump does not start.
Insufficient or no pump delivery.
The LED lighting is not on.
The unit cannot be switched on.
Cause
No connection to the battery house.
The solar module is soiled.
The impeller unit is blocked.
The battery capacity is exhausted.
The rechargeable battery is defective.
The solar module is not connected.
The mode "Solar powered" is activated but there is insuf-
ficient sunlight.
The mode "Battery powered" is activated but the battery
capacity is exhausted.
The filter is clogged.
The nozzle unit is clogged.
The impeller unit is worn.
No connection to the battery house.
The mode "Solar powered" is activated but there is insuf-
ficient sunlight.
The mode "Battery powered" is activated but the battery
capacity is exhausted.
No connection to the battery house.
The LED lighting is soiled.
The LED lighting is defective.
The mode "Battery powered" is not activated.
The mode "Battery powered" is activated but it is not suf-
ficiently dark.
The rechargeable battery is defective.
The rechargeable battery is not connected.
Remedy
– Connect the pump to the battery house.
– Push the plug completely into the socket (up
to the stop).
Clean
Clean
Charge the battery for at least 3 hours.
Replace
Connect
Direct sunlight
Charge the battery for at least 3 hours.
Remove the filter housing, remove and clean
the filter.
Remove and clean the nozzle unit.
Replace
– Connect the pump to the battery house.
– Push the plug completely into the socket (up
to the stop).
– Align the solar module to the sun.
– Activate the mode "Battery powered".
Charge the battery for at least 3 hours.
– Connect the LED lighting to the battery
house.
– Push the plug completely into the socket (up
to the stop).
Clean
Dispose of the LED lighting.
Activate
Cover the solar module.
Replace
Correctly fit the cable shoes.
(→ Replacing the rechargeable battery)
- EN -
13