Standard Accessories; Battery Removal/Installation; Optional Accessories - Hitachi WH 14DBAL2 Instrucciones De Manejo

CHARGER
Model
Charging voltage
Weight

STANDARD ACCESSORIES

In addition to the main unit (1), the package contains the
accessories listed in the table below.
1 Charger ............................................. 1
WH14DBAL2
2 Battery ............................................... 2
WH18DBAL2
WR14DBAL2
3 Plastic case ....................................... 1
WR18DBAL2
4 Battery cover .................................... 1
Standard accessories are subject to change without
notice.

OPTIONAL ACCESSORIES

(Sold separately)
Battery
(BSL1430, BSL1440)
Optional accessories are subject to change without notice.
The
Before
pilot charging
lamp
lights or
While
blinks in
charging
red.
Charging
complete
Charging
impossible
The Overheat
pilot lamp standby
lights in
green.
UC18YRSL
14.4 V – 18 V
0.6 kg
(BSL1830, BSL1840)
Indications of the pilot lamp
Blinks Lights for 0.5 seconds. Does not light for 0.5
seconds. (off for 0.5 seconds)
Lights Lights continuously
Blinks
Lights for 0.5 seconds. Does not light for 0.5
seconds. (off for 0.5 seconds)
Lights for 0.1 seconds. Does not light for 0.1
Flickers
seconds. (off for 0.1 seconds)
Lights Lights continuously
APPLICATION
< WH14DBAL2 / WH18DBAL2 >
Driving and removing of machine screws, wood
screws, tapping screws, etc.
< WR14DBAL2 / WR18DBAL2 >
Tightening and loosening of all types of bolts and
nuts, used for securing structural items

BATTERY REMOVAL/INSTALLATION

1. Battery removal
Hold the handle tightly and push the battery latch to
remove the battery (see Fig. 2).
CAUTION:
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (see
Fig. 2).
CHARGING
Before using the power tool, charge the battery as follows.
1. Connect the charger's power cord to a receptacle.
When the power cord is connected, the charger's
pilot lamp will blink in red. (At 1-second intervals)
2. Insert the battery into the charger.
Firmly insert the battery into the charger until the line
is visible, as shown in Fig. 3, 4 .
3. Charging
When inserting a battery in the charger, charging will
commence and the pilot lamp will light continuously
in red.
When the battery becomes fully recharged, the pilot
lamp will blink in red. (At 1-second intervals) (See
Table 1)
(1) Pilot lamp indication
The indications of the pilot lamp will be as shown in
Table 1, according to the condition of the charger or
the rechargeable battery.
Table 1
English
Malfunction in the
battery or the charger
Battery overheated.
Unable to charge
(Charging will commence
when battery cools).
10