Tabla de contenido
Publicidad
EN
mechanism to the correct open position for
the size of comb you are using (see fig. D).
Begin with the front cover sheet and
insert up to 15 sheets of the punched
document face down into the open teeth
of the binding comb. Repeat and finish
with the rear cover sheet (see fig. F).
Close the binding comb opener by push-
ing the comb opening levers
away from you.
Slide the bound document to the left to
disengage the binding mechanism and
and lift off the finished document.
Rear Hole Punch (A4 4 hole /
LTR 3 hole) (see fig. G)
Turn rear of machine to face you.
Slide a maximum of 4 sheets into the rear
punching slot
5
guide on left side of slot.
Push down on punch lever
position.
Lift the punching lever and remove the
paper.
Note: uBind 1.0 A4 size machine has a
rear 4-hole punch for punching paper for
for ring binders and uBind 1.0 LTR size
machine has a rear 3-hole punch for
punching paper for ring binders.
Waste Containers (see fig. H)
Open the cover of one waste container
on the bottom of the machine, tilt the
machine over a waste bin and shake the
machine slightly. Repeat with second waste
container. Empty waste containers regularly.
Binding Tips
Always start binding with the front cover
and add the document pages face down,
finishing with the back cover. This way the
ends of the fingers of the binding comb are
8
uBind_1.0_Binding_machine_content_EU.indd 8
and
2
3
using the inbuilt paper
to the stop
1
7
at the rear of the document providing a
neater, more professional finish.
To utilise the maximum capacity of the
binding comb – close the comb after in-
serting approximately two thirds of the
sheets (see fig. B). Next press the sheets
of paper down in front of the red horizontal
hooks (see fig. C). Reopen the comb (see
fig. D) and continue binding (see fig. E).
This method exposes more of the remain-
ing space on the teeth of the comb and
allows the last sheets to be more quickly
and easily inserted onto the comb.
To add or remove sheets from a bound
document – place the bound document
(ends of comb teeth facing up) onto the
fingers of the binding mechanism. Slide doc-
ument to right onto the binding mechanism
hooks. Open the binding mechanism
by pulling the side comb opening levers
and
towards you to open document.
3
Remove, replace or add sheets where
required. Close the binding comb opener
by pushing the comb opening levers
and
away from you. Slide the bound
3
document to the left to disengage the
binding mechanism and and lift off the
finished document.
6
2
2
09.05.16 11:44
Publicidad
Tabla de contenido
