FALMEC GRUPPO 3330 Manual De Instrucciones página 23

O
MOUNTING INSTRUCTIONS, RANGE
HOODS WITH BOX
Step 1
- Drill holes necessary for mounting.
- Insert the unit on the bottom of the wall unit. The springs (M) allow tempo-
rary hooking to the wall unit panel (see fig. 1).
Step 2
- Open the panel (P) and tighten the screws (A) until the spring (M) holds
against the wall unit panel (see fig. 2). By tightening the screw (A), the spring
(M) opens up and blocks the unit against the panel. This is shown in figure.
Make sure that the unit is tightly fastened to the cabinet and then close the
panel (P).
Step 3
- In the ventilation version, connect the output pipe connection of the motor
to the external air discharge hole.
- Only complete electrical connection after disconnecting the electrical power.
If removing the unit for extraordinary maintenance (carried out by qualified
personnel): open the panel (P) and loosen the screws (A), first on one side
and then on the other, so that the unit moves downward until it comes out
of its seat. Support the unit to make sure that it does not unhook suddenly.
21