Makita TD022D Manual De Instrucciones página 5

Lock lever
CAUTION:
When not operating the tool,
always set the lock lever in the locked position
► 1. Lock lever 2. Switch
When the lock lever is in the locked position
switch cannot be actuated.
When the lock lever is in the unlocked position
switch can be actuated.
Switch action
CAUTION:
Before installing the battery car-
tridge into the tool, always check to see that the
switch trigger actuates properly and returns to
the "OFF" position when released.
CAUTION:
Always check the direction of
rotation before operation.
NOTICE:
Change the direction only after the tool
comes to a complete stop. Changing the direction
of rotation before the tool stops may damage the tool.
To start the tool, first move the lock lever to the
unlocked position to release the switch.
► 1. Lock lever 2. Switch
And then turn the switch to A side for clockwise rotation
or to B side for counterclockwise rotation.
Tool speed is increased by increasing rotation angle on
the switch. Release the switch to stop.
1
2
, the
, the
1
2
.
► 1. Switch
Lighting up the front lamp
CAUTION:
source of light directly.
To turn on the lamp only, first move the lock lever to the
unlocked position
or B side a little.
Release the switch to turn off the lamp.
► 1. Lamp 2. Lock lever 3. Switch
NOTE: Use a dry cloth to wipe the dirt off the lens of
the lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
ASSEMBLY
CAUTION:
switched off and the battery cartridge is removed
before carrying out any work on the tool.
5 ENGLISH
B
A
A
B
1
Do not look in the light or see the
. And then rotate the switch to the A
3
1
Always be sure that the tool is
2
A
B