Functional Description - Makita HR4041C Manual De Instrucciones

･
hertz
･
alternating current
･
no load speed
･
Class II Construction
･
revolutions or reciprocation per minute
･
number of blow

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function on
the tool.
Switch action
007781
CAUTION:
Before plugging in the tool, always check to see
•
that the switch trigger actuates properly and
returns to the "OFF" position when released.
Do not tape, tie or otherwise secure the trigger in
•
the "ON" position.
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
Speed change
007785
The revolutions and blows per minute can be adjusted
just by turning the adjusting dial. The dial is marked 1
(lowest speed) to 5 (full speed).
1. Switch trigger
1
1. Adjusting dial
1
Refer to the table below for the relationship between the
number settings on the adjusting dial and the
revolutions/blows per minute.
Number on Revolutions per
adjusting dial minute
5
4
3
2
1
007885
CAUTION:
If the tool is operated continuously at low speeds
•
for a long time, the motor will get overloaded,
resulting in tool malfunction.
The speed adjusting dial can be turned only as far
•
as 5 and back to 1. Do not force it past 5 or 1, or
the speed adjusting function may no longer work.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
Side grip (auxiliary handle)
1
007796
For maximum control and safer operation, always use
the side grip with this tool. The side grip swings around
to either side, allowing easy handling of the tool in any
position. Loosen
counterclockwise, swing it to the desired position and
then tighten it by turning clockwise.
Bit grease (optional accessory)
Coat the bit shank head beforehand with a small amount
of bit grease (about 0.5 -1 g; 0.02 - 0.04 oz.). This chuck
lubrication assures smooth action and longer service
life.
4
Blows per minute
460 2,600
420 2,400
350 2,000
270 1,500
230 1,300
1. Side grip
the side grip by turning it