Alesis BASSFIRE 60 Manual De Usuario página 9

ROUTE
The order of the effects chain can be changed here.
After you've created a configuration that you like, you can store it for future recall.
To store your changes, press the VALUE knob and then turn the knob to select a
store location. Press the VALUE knob again to store the program.
Copying effects programs from one location to another
Copying programs is easy. Just call up the program that you want to copy. Then,
press the VALUE knob, twist it until you find the location where you want to store
your copy, and press VALUE again to store the program in its new location.
Restoring factory defaults for the effect settings
Once you have saved changes to a preset program, you can still recall the original
settings. To enter the RESTORE FACTORY PRESETS mode, simply hold down the
VALUE knob as you turn the unit on and then select the program to be restored
(or AL for all programs). Press the VALUE knob to confirm your selection. The
display will blink rapidly several times to indicate the restore was successful. Any
program changes you have made will be lost, so you might want to copy the
program to another location first.
To exit the RESTORE FACTORY PRESETS mode, just turn the EFFECTS knob.
You can also turn the Bassfire off and then on again, without holding down any
knobs or buttons, to exit the RESTORE FACTORY PRESETS mode.
This is the default order.
This one is the default order with FX2 and FX3 swapped to put the delay
effects in the middle of the modulation effects.
This order places the cabinet simulator at the end.
This one is order 2 with FX2 and FX3 swapped.
This order is the default order with the compressor/limiter placed at the
end, making this one ideal for recording.
This one is order 4 with FX2 and FX3 swapped.
This is the one to go for if you're recording and want to sound like
you're running several effects pedals into an amp.
This configuration is order 6 with FX2 and FX3 swapped.
Storing effects programs
7