Base Station; Replacing The Batteries; Measuring Station - Hama EWS-3000 Instrucciones De Uso

Warning – Batteries
• Immediately remove and dispose of dead batteries from
the product.
• Only use batteries (or rechargeable batteries) that
match the specified type.
• Do not mix old and new batteries or batteries of a
different type or make.
• When inserting batteries, note the correct polarity
(+ and - markings) and insert the batteries accordingly.
Failure to do so could result in the batteries leaking
or exploding.
• Do not overcharge batteries.
• Keep batteries out of the reach of children.
• Do not short circuit the batteries/rechargeable batteries
and keep them away from uncoated metal objects.
4. Getting Started
Note
Always make sure to start the measuring station first and
then the base station.

4.1. Measuring station

• Open the battery compartment (32), remove the contact
breaker and then close the battery compartment (32).
• Press the CH button (29) repeatedly to select the channel
the measuring station is to use for transmission. CH1, CH2
or CH3 is shown on the display.
• Press the °C/°F button (31) to choose between °C and °F
for the temperature display.
• Then close the battery compartment cover.

4.2. Base station

• Open the battery compartment (25) and insert three
AA batteries with the correct polarity into the battery
compartment (25). Then close the battery compartment
cover.

4.3. Replacing the batteries

Note – Replacing the batteries
• Note that the stations have to be resynchronised each
time after you change the batteries in the measuring
or base station.
• To do this, remove the batteries from the other station
and then reinsert them, or change them as required.
Measuring station
• When the symbol (3) appears, replace the 2 AAA
batteries for the measuring station with 2 new ones.
• Open the battery compartment (32), remove and properly
dispose of the depleted batteries, and insert two new AAA
batteries with the correct polarity. Then close the battery
compartment cover.
Base station
• When the symbol (5) appears, replace the 3 AA
batteries for the base station with 3 new ones.
• Open the battery compartment (25), remove and properly
dispose of the dead batteries and insert 3 new AA
batteries with the correct polarity. Then close the battery
compartment cover (25).
5. Installation
Note – Installation
• We recommend initially placing the base and
measuring stations in the intended locations without
installing them and making all the settings described in
6. Operation – to do.
• Only install the stations once the appropriate settings
have been made and a stable wireless connection is
established.
3