Hama EWS-3000 Instrucciones De Uso página 6

Note
• The wireless transmission range between the measuring
and base stations is up to 30 m in open spaces.
• Before installation, ensure that wireless transmission
will not be disrupted by interference or obstacles like
buildings, trees, vehicles, high-voltage lines, etc.
• Before the final installation, ensure that there is
sufficient reception between the intended installation
locations.
• When installing the measuring station, ensure that it is
protected from direct sunlight and rain.
• The international standard height for measuring air
temperature is 1.25 m (4 ft) above ground.
Warning
• Buy special or suitable installation material from a
specialised dealer for wall-mounting.
• Ensure that no faulty or damaged parts are installed.
• Never apply force during installation. This could
damage the product.
• Before installation, ensure that the chosen wall is
suitable for the weight to be mounted, and make sure
that there are no electrical wires, water, gas or other
lines at the installation site on the wall.
5.1. Base station
• Use the base to position the base station on a level surface.
• Alternatively, you can install the base station on a wall
using the opening on the back.
5.2. Measuring station
• You can also position the measuring station on a level
outdoor surface.
• We recommend installing the measuring station securely on
an outdoor wall using the recess (30).
4
6. Operation
Note
Hold down the + button (22) or the – button (23) to
select the values faster.
6.1. Connection to the measuring station
• After you insert the batteries, the base station automatically
searches for a connection to the measuring station and
performs initial setup.
Note
• Initial setup takes approx. 3 minutes.
• During the connection attempt, the measuring station
radio symbol (1) will flash.
• Do not press any buttons during setup. Otherwise,
values may not be transmitted correctly and there is a
risk of value errors and inaccuracies.
• The setup process is completed when the indoor (6)
and outdoor (4) measurement data is displayed
• If the base station still does not receive a signal from the
measuring station, press and hold the Channel button
(24) for approx. 3 seconds to start the manual search for
the signal.
6.2. Basic and manual settings
Automatic setting using the DCF signal
• After the first time the base station is switched on and
successful transmission is established between the
base station and the measuring station, the clock will
automatically search for a DCF signal. During the search,
the wireless symbol (14) will flash.
Display (14)
Display flashing
Displayed continuously
No display
Searching for the DCF signal
Active
Successful –
signal is being received
Inactive