Functional Description - Makita PJ7000 Manual De Instrucciones

could give the operator an electric shock.
4. Use only the blades specified for this tool.
5. Never operate the tool with the blade locked in
exposed position or without the blade cover
secured properly in place.
6. Make sure that the blade slides smoothly
before operation.
7. Check the blades carefully for cracks or
damage before operation. Replace cracked or
damaged blades immediately.
8. Make sure that the flange fits in the arbor hole
when installing the blade.
9. Inspect for and remove all nails or foreign
matter from the workpieces before operation.
10. Always place the workpieces on a stable
workbench.
11. Secure the workpieces firmly with clamp or
vise.
12. NEVER wear gloves during operation.
13. Hold the tool firmly with both hands.
14. Keep your hands and body away from the
grooving area.
15. Run the tool for a while without the blade
pointing toward anybody. Watch for vibration
or wobbling
installation or a poorly balanced blade.
16. Never reach your hands underneath the
workpieces while the blade is rotating.
17. Do not leave the tool running unattended.
18. Always be sure that the tool is switched off
and unplugged
adjustments or replacing the blade.
19. Some material contains chemicals which may
be toxic. Take caution to prevent dust
inhalation and skin contact. Follow material
supplier safety data.
20. Do not use blunt or damaged blades.
21. Do not use the tool with damaged guards.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to safety rules for the subject product. MISUSE or
failure to follow the safety rules stated in this
instruction manual may cause serious personal
injury.
that could indicate
before making
Symbols
The followings show the symbols used for tool.
･
･
･
･
･
･
･

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function on
the tool.
poor
Adjusting the depth of groove
any
3
012682
6 grooving depths can be preset according to the size of
biscuit to be used.
Refer to the table below for the correspondence between
the sizes marked on the stopper and the biscuit size.
Fine adjustments to the grooving depth can be made by
turning the adjusting screw after loosening the hex nut.
This may become necessary after the blade has been
resharpened a few times.
Size on stopper
Biscuit size
Depth of groove
* With the rubber spikes removed.
012683
Angle guide
The angle guide height can be moved up and down to
adjust the position of the blade in relation to the top of the
workpiece.
4
volts
amperes
hertz
alternating current
no load speed
Class II Construction
revolutions or reciprocation per minute
1
4
2
0 10 20
0 10 20
8 mm 10 mm 12.3mm 13 mm
(0.3") (0.4") (0.48") (0.51")
USD201-2
1. Pointer
2. Stopper
3. Adjusting screw
4. Rubber spike
S D MAX
- - -
*
14.7mm 20 mm
(0.58") (0.8")