SATA adam 2 Serie Instrucciones De Servicio página 301

The following applications and operations lead to the loss of
the explosion protection and are, therefore, prohibited:
• Battery replacement in explosive areas!
• Installation of a battery other than CR 2032, RENATA (SATA Art. No.
160739)!
7. Use [2]
• Please disconnect the spray gun from the air supply prior to the installation
of the SATA adam 2 or the dock to the spray gun.
• Please ensure that all screws are firmly tightened.
1. Loosen and remove the locking screw [2-1].
2. Remove air micrometer (air flow control knob) [2-2].
3. Insert SATA adam 2 [2-3] in the spray gun.
4. Tighten locking screw firmly [2-4].
Warning!
• Check if locking screw has been firmly tightened! SATA adam 2 (mini)
could otherwise shoot out from the spray gun in an uncontrolled way!
7.1. Disassembly and Assembly of the Display [3]
Disassembly:
• Place the regulation wing [3-1] in the horizontal centre position.
• Press down the locking clip [3-2] and slide display [3-3] upwards out of
the groove.
Assembly:
• Place the regulation wing [3-4] in the horizontal centre position.
• Place display [3-5] correctly in the groove and slide in until it snaps
home.
<< Operating Instructions SATA adam 2 >>
Danger! Risk of explosion!
Danger! Notice!
US
XXVI.5