Troubleshooting Guide; Disposal Information - MIRKA LEROS 2AK2S-LCX Instrucciones De Manejo

Further service
Servicing must always be performed by trained personnel . To keep the tool warranty valid and ensure optimal tool
safety and performance, servicing must be carried out by a Mirka authorized service center . To locate your local Mirka
authorized service center, contact Mirka Customer Service or your Mirka dealer .

Troubleshooting guide

Symptom
The multi-purpose LED is flashing
between red and green.
No light from multi-purpose LED when
switched on.
The multi-purpose LED is red and the
sander slows down to 4,000 rpm when
sanding.
The multi-purpose LED is red and RPM
is slightly reduced.
Brake seal does not work.
The sander has stopped and multi-
purpose LED is red.

Disposal information

DANGER
Disposal guidelines for old appliances . Render redundant power tools unusable by removing the
power cord . Only for EU countries: Do not dispose of electric tools along with household waste .
According to European Directives 2002/95/EC, 2012/19/EU and 2003/108/EC on waste electrical and
electronic equipment and their implementation under national law, electric tools that have reached
the end of their life must be collected separately and taken to an environmentally compatible
recycling facility .
Possible cause
Connected to a mains outlet with wrong
voltage .
Power cord not properly attached to the
sander or to the mains socket .
Temperature too high in the sander . Too
heavy long-term load .
Too heavy short-term load .
Worn out brake seal or damaged spindle
bearing .
The tool is in safety mode due to high
temperature .
Mirka® LEROS Random Orbital Sander • 125 mm (9") • 110 V
Solution
Connect the sander to a mains outlet that
matches the nominal voltage of the tool .
Connect it properly .
Reduce the load on the sander for some
time and the sander will speed up again .
Use lighter load and the multi-purpose
LED will automatically change to green .
Check and replace brake seal or spindle
bearing if necessary .
Wait until the tool has cooled down .
en
15