Connecting The Mobile Dust Extractor; Connecting Electric Power Tools; Connecting Pneumatic Tools - Festool CTM 26 E Manual De Instrucciones

The specified illustrations appear at the beginning
of the Operating Instructions.
5 Intended use
Mobile dust extractor suitable for
– Extracting dust up to 1 mg/m³ according to dust
class 'L',
– Extracting water,
– Increased loads during commercial use,
according to IEC/EN 60335-2-69.
The user is liable for improper or non-in-
tended use.
6 Operation
WARNING
Unauthorised voltage or frequency!
Risk of accidents

Observe the specifications on the machine's
name plate.

Observe country-specific regulations.
6.1 Initial operation

Insert the filter/disposal bag [2].

Attach the cord holder [3].

Connect the suction hose [4].
6.2

Connecting the mobile dust extractor

WARNING
Risk of injury from tools starting up unexpectedly

Before setting the switch to the "AUTO" or
"MAN" position, make sure that the connected
tool is switched off.
The switch [1-8] serves as an on/off switch.
Switch position "0"
Appliance socket [1-3] is disconnected from the
power, mobile dust extractor is switched off.
"MAN" switch position
Appliance socket [1-3] is connected to the power,
the mobile dust extractor starts.
"Auto" switch position
Appliance socket [1-3] is connected to the power,
the mobile dust extractor starts when the connect-
ed tool is switched on.

Insert the plug into an earthed socket.
Pull the plug from the socket when the ma-
chine is not in use and prior to maintenance
and cleaning work.
6.3

Connecting electric power tools

WARNING
Risk of injury

Observe the maximum appliance socket con-
nected load (see chapter "Technical data")

Switch off the electric power tool.

Connect the electric power tool to the appliance
socket [1-3].
Special features of CTL26 E SD
– CTL 26 E SD E/A: Socket module with automatic
switch-on function for the use of two electric
power tools: e.g. 2 sanders, 1 jigsaw + 1 sander
– CTL 26 E SD: Socket module with permanent
power supply for use as extension cable: e.g.
charger, lamp, etc.
6.4

Connecting pneumatic tools

WARNING
Risk of injury

Switch off the air tool.
Automatic on/off switch for air tools (CTL 36/48 E
LE, CTL 36/48 E LE AC or accessories)
with compressed air module in module slot [1-2]
Recommendation:
– Attachment of service unit VE (495886): com-
pressed air filtered and lubricated
– Use of IAS system with IAS connector (454757)
for Festool air tools
Requirement: tool with operating pressure of
6 bar!
6.5 Special features of the CTL 36 E AC- LHS
To use the mobile dust extractor in combination
with the PLANEX:

Use kink-resistant suction hose D 36 mm x 3.5
m-AS.

Use a special suction sleeve for connecting the
PLANEX.

Use closing slide CT-VS between the intake
opening [1-1] and suction hose.

Attach the tool holder.

Always use with a disposal bag!
CTL
GB
13