Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Heating applications are affected
by several factors. The density of
the material being heated, ambient
temperature,
between the nozzle and the surface
being heated and the heating
technique will all affect the speed at
which the surface will be heated.
During the heating process, it is very
important to maintain a consistent
distance between the nozzle and
the surface being heated.
NOTE: The nozzle must be at least
2"(25 mm) from the surface being
heated to permit adequate air flow
and to prevent overheating.
Always keep the heat gun in
motion during the heating process.
Inadequate motion will result in
overheating and possible damage
to the surface or to the heat gun.
WARNING
Have you read "POWER TOOL
SAFETY",
"SPECIFIC
RULES",
EXTENSION
SAFETY" and "SYMBOLS" of this
Manual? If not, please do it now
before you operate this heat gun.
Your safety depends on it!
Every time you use the heat gun
you should verify the following:
wind,
distance
SAFETY
CORD
1. The nozzle is not obstructed
with debris
2. Appropriate safety glasses,
respirator mask and protective
clothing are being won.
3. Area adjacent to the heating
application
is
combustible materials.
4. Availability of water or fire
extinguisher in case of a fire.
Failure to adhere to these safety
rules can greatly increase the
chances of injury or property
damage.
clear
of
all
8
Publicidad
Tabla de contenido
