Sears Kenmore 233.57800890 Manual De Uso Y Cuidado / Instalacion página 3

Always turn ON your hood before you begin cooking in order
to establish an air flow in the kitchen. Let the blower run for a
few minutes to clear the air after you turn off the range. This
will help keep the whole kitchen cleaner and brighter.
= =-c=.O = ,o-,
2 ° \ 1 2 4 1/ 2
HC0005
1. Warming lamp switches
2. Halogen lights
3. Halogen light switches
4. ON/OFF Blower switch
5. Blower speed control
Grease filters
The grease filters should be cleaned frequently. Use a warm
detergent solution.
Wash more often if your cooking style generates greater
grease - like frying foods or wok cooking.
Remove filters by pushing filters towards the back of hood
and rotating filters downward.
Impeller(s)
Remove the grease filters. To remove the impeller(s), take off
the cover by unlatching both sides of the blower, then, remove
impeller(s) by pulling it (them) out. See pictures below.
Warming Lamps (Infrared)
Each warming lamp (not shown) is controlled with is own ON/
OFF switch (item 1 on picture above).
Use only 120V, IR175W, PAR38, infrared bulbs.
(Sears part # 57852.)
_/_ WARNING: Do not place highly flammable
material on warming shelves.
Cooktop Lighting (Halogen)
A double set of ON/OFF switches (item 3 on picture above)
control the halogen lights (item 2 on picture above).
The front rocker controls the center light for 42" and 48"
hoods). The rear rocker controls both side lights (each switch
controls one light for 30" and 36" hood). Select one, two, or
three lights for best cooktop lighting.
Use PAR 20, 50W halogen bulbs. (Sears part # 57853.)
Blower
The blower is operated using two (2) controls.
Use the ON/OFF blower switch (item 4 on picture above) to
start and stop the blower. When turned on, the blower will
operate at the previous setting of the speed control (item 5 on
the picture above).
Turn the speed control knob clockwise to decrease blower
speed - counterclockwise to increase speed.
HEAT SENTR_
Your hood is equipped with a HEAT SENTR_ thermostat.
This thermostat is a device that will turn on or speed up the
blower if it senses excessive heat above the cooking surface.
1) If blower is OFF - it turns blower ON to high speed.
2) If blower is ON at a lower speed setting - it turns blower up
to HIGH speed.
When the temperature level drops to normal, the blower will
return to its original setting.
_b WARNING: The HEATSENTRY TMthermostatcan
start the blower even if the hood is turned OFF.
When this occurs, it is impossible to turn the
blower OFF with the switch. If you must stop
the blower, do it from the main electrical panel.
HD0021
HD0022
There is a tab on the interior ring of the wheel, make sure it fits
into one of the holes on the motor (you will feel it fall into
position). Reinstall impeller(s) and cover.
,_ CAUTION: For dual blower unit, make sure the
impellers are correctly installed; the hood will
not work properly if the impellers are reversed.
Both impellers are different in the dual blower, one rotates
clockwise and the other counterclockwise. Each wheel and
motor have an arrow and a number on them, you have to
match them correctly. See illustration below.
HDO023
O
=
cn
_b
"t
Cb
3