Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
CLEANING & STORAGE
•
Unplug the appliance from the wall outlet.
•
Do not immerse the motor unit or power cord into water or other liquids.
•
Clean surface of the blender jar with soft cloth or spongy. The measuring cup and the seal ring can be disassembled for
cleaning.
•
The blender jar can be rinsed with water. It can also be cleaned by filling 2 cups of water in the blender jar, close the lid and
then operate the blender in Pulse mode. Then pour out the water and dry it with soft cloth.
•
After cleaning, put the blender jar on the side or upside down (Note 1) to dry. Do not immerse the whole jar in water.
•
Clean the motor unit by soft cloth. NEVER put it in water.
Note 1 : If put the blender jar in upside down position, please remove the residual water by dry cloth. Do not leave it close
to the sink or basin to avoid water spraying to the bottom part of the jar. This may cause the rusting of the bearing
and hence affecting the performance of the blender.
NOTICE FOR OPERATION
•
If the motor is dragged to a low speed since the food is too thick or there is too less liquid in the jar, and operates for a
proloned period, the temperature monitoring system will trigger and stop the operation of the motor. In this case, unplug
and put the blender to a place with good ventilation to cool down the motor temperature for 45 minutes. The system will
reset and the blender can be used again.
•
During operation, close the lid tightly to avoid scalding due to spraying of hot liquids.
•
Keep hands and utensils out of the container while the motor is running to prevent the possibility of severe personal injury
and/or damage.
•
In making hot beverage such as soybean milk, hot soup, please check whether the lid is secured tightly to the jar to prevent
it from falling. It is advisable to start the operation at low speed setting and increase the speed gradually, or use the Pulse
Drive mode.
•
When making sauces (eg. Almond sauce, jam and sesame sauce), stuffing and nuts,put in between 2 and 3 cups of
ingredients. The amount should neither be too large or too little. Keep the blending time below 2 min. to prevent any burnt
smell due to overheating. Too much ingredients may lead to overlaoding and overheating of the motor. In this case, wait till
the motor temperature fall before operating again.
•
Please put liquid and soft food before putting in hard food or ice cubes.
•
When the operation finishes, please wait until the blade assembly comes to a complete stop before taking up the blender
jar. Otherwise, the Drive Gear may be damaged.
•
If you feel a scorch smell from the blender, stop the operation immediately. It may be caused by the abrasion at the rubber
cushion base if it is not properly assembled.
•
l When blending thick and sticky food using high speed, please start the operation at low speed. If the turning is still idle,
disconnect the power and stir the blender jar using a rubber stirrer to drive out the air capsule trapped in the food. Then
close the lid and switch on to proceed the operation
•
l Do not operate for more than 10 minutes at a time.
8
Publicidad
Capítulos
Tabla de contenido
