Publicidad
Idiomas disponibles
Idiomas disponibles
Hood Surface
Painted Surfaces:
For general care, wipe the outside of the hood with sudsy
water or household cleaners such as Fantastic
409
, rinse well and dry with a clean soft cloth to avoid water
®
marks.
Stainless Steel Surfaces:
Wipe and dry stainless steel in the same direction as the grain.
Avoid using too much pressure, which may mar the surface.
To remove finger prints and give added shine, use cleaners
such as Stainless Steel Magic
Do not allow any cleaning compounds to remain in contact with
stainless steel for extended periods.
Filters
The hood has removable aluminum filters that must be cleaned
when they collect grease.
The filters can be cleaned with soap and water or in the
dishwasher.
DAH95 models are equipped with a filter light that will illumi-
nate after 40 hours of operation. The light indicates that the
filters need to be cleaned.When used over a wok or other
high grease application, more frequent cleaning may be re-
quired.
Remove the filters for cleaning: push the handle in and
pull down. The front will come out first. Then pull the back
down and out. See Figure 2.
To replace the filters: insert the back ends first, then while
holding the handles, push in and up until the filters are se-
cured in place.
Lights
Use a Par 20 halogen light bulb. For DAH 93 models only, an
R20 incandescent bulb can also be used.
NOTE: Turn off the lights and fan and allow lights to cool
before handling. If lights do not operate upon installation, check
for proper insertion. Light bulbs can be cleaned with soap and
water.
CAUTION
TURN POWER OFF AT BREAKER BEFORE
REMOVING A DAMAGED BULB. DO NOT TOUCH
THE BULBS IMMEDIATELY AFTER USE. THE BULBS
WILL REMAIN HOT FOR SEVERAL MINUTES.
Light Bulb Replacement
Remove the damaged light bulb by turning counter-clockwise.
Replace with a new 50W flood light bulb. Models DAH95,
DAH94 and DAH93 use a Par 20 halogen light bulb. Model
DAH93 can use a R20 incandescent bulb. Follow package
directions.
Buttons
Wipe with sudsy water or household cleaners such as Fantastic
or Formula 409
, rinse well and dry with a clean soft cloth to
®
avoid water marks.
Care, Cleaning and Maintenance
or Formula
®
.
®
Be sure the entire hood (including the filters and light
bulbs) has cooled and grease has solidified before
attmepting to clean any part of the appliance.
1
Do not use cooktop while hood is disassembled, to
insure adequate ventilation.
Figure 2 - Filters
DO NOT use the following!
Do not use the following cleaning agents on any of the
hood components:
Abrasive Pads such as those made from steel wool
(SOS
, Brillo
®
Abrasive cleaners such as Comet
Flammable products such as gasoline or kerosene.
®
PAGE 4
WARNING
) or plastic mesh.
®
, Ajax
®
and Zud
.
®
®
Publicidad
