Remote Control - Aiwa LCX-357 Manual De Instrucciones

To position the antennas
FM feeder antenna:
Extend this antenna horizontally in a T-shape and fix its ends to
the wall.
AM loop antenna:
Position for the best reception.
To stand the AM loop antenna on a surface
Fix the claw to the slot.
NOTE
• Do not short-circuit the 0 and 9 speaker cord leads, otherwise
the sound may become inaudible or the unit may be turned off.
If this happens, disconnect the AC cord from the AC outlet and
re-connect the speaker cord correctly. Then connect the AC
cord and turn the unit on again.
• Do not connect any speakers to the unit other than the supplied
ones.
• Do not leave objects generating magnetism near the speakers,
as these objects may be damaged.
• Do not bring the FM antenna near metal objects or curtain rails.
• Do not bring the AM loop antenna near other optional
equipment, the stereo system itself, the AC cord or speaker
cords, since noise will be picked up.
• Do not unwind the AM loop antenna wire.
CONNECTING AN OUTDOOR ANTENNA
For better FM reception, use of an outdoor antenna is
recommended.
Connect the outdoor antenna to FM 75 Ω terminals.
To connect other optional equipment

REMOTE CONTROL

Inserting batteries
Detach the battery cover on the rear of the remote control and
insert two size AA (R6) batteries.
When to replace the batteries
The maximum operational distance between the remote control
and the sensor on the main unit should be approximately 5 meters
(16 feet). When this distance decreases, replace the batteries
with new ones.
Using the FUNCTION button
The FUNCTION button substitutes for the function buttons (TAPE/
REV MODE, TUNER/BAND, CD, AUX) on the main unit.
Each time FUNCTION is pressed, the next function is selected
cyclically.
NOTE
• c on the remote control has the same function as d on the
main unit.
• If the unit is not going to be used for an extended period of
time, remove the batteries to prevent possible electrolyte
leakage.
• The remote control may not operate correctly when:
– The line of sight between the remote control and the remote
sensor is exposed to intense light, such as direct sunlight
– Other remote controls are used nearby (television, etc.)
page 18.
R6(AA)
En
5
ENGLISH