Maintaining The Power-Off Control Of The Brake Lever; Simple Trouble Shooting - TXED BIKE E-FOLDING XV Instrucciones De Uso

Note: If you think water may have got into the control box, please switch off the power immediately and pedal
without electric assistance. You can pedal with electric assistance as soon as the controller has dried out.
9.2 Pay attention to protect from any strong shaking and punching, which may damage this controller
9.3 The controller should be used in normal working temperature range from -15°C to +40°C
Warning:
modify or adjust the controller will void the warranty. Please ask your local dealer or
authorized service specialist to repair your bike.

10. Maintaining the Power-off Control of the Brake Lever*

This is a very important component for riding with safety. First, you should pay attention to protect it from
impact and avoid any damage. Second, make regular check on all bolts and nuts, and fasten them securely.

11. Simple Trouble shooting.

The information below is for purpose of explanation, not as a recommendation for user to carry out repair.
Any remedy outlined must be carried out by a competent person who is aware of the safety issues and
sufficiently familiar with electrical maintenance.
Trouble Description
After the main battery
switched on, the motor
does not generate
assistance when
pedaling.
Do not open the controller box. Any attempt to open the controller box,
Possible Causes
1)the motor cable
connection joint) is loose; 2) brake
lever did not return well, which
keeps the switch in "power off"
position; 3) battery fuse is broken; 4)
the speed
is too far away from the magnetic
ring on the B.B. axle; 5) the
connection between the sensor and
the controller is loosen or not
connected well.
(waterproof First of all, please check the battery if it is
empty.
immediately. 1) check if the connection is
securely fixed. If loose, joint them tightly. 2)
make the brake lever come back to its normal
sensor position with care, without braking; 3) open
the battery pack top, and check if the fuse is
broken. If yes, please visit your vendor or
authorized service for installing a new fuse; 4)
adjusting the distance between the magnetic
ring and the sensor, to make sure the
distance is within 3mm; 5) fix tight the
connection between the sensor and the
controller.
Trouble shooting
If yes, charge the battery
14/85