Battipav CLASSplus 66900 Manual De Instrucciones página 26

GB
tightened;
• the tube-holder rod is out of its housing.
• the feet are closed with the leg locking pin.
TO MOVE THE MACHINE
4
a) Use a 4 (four)-arm tie rod, making use of the
hooks in the transport handles.
3 b) With the aid of a second person, move the
machine by means of the transport handles.
4 To move the machine, use a four-arm tie rod
with the capacity to lift 200 kg or at least 20%
more than the machine weight, by making use
of the hooks in the transport handles.
HANDLING
By using the "transport wheels" accessory (standard
for Art. 66901, 661101, 661351), the machine can be
moved with the aid of a second person.
CAUTION
IN ORDER NOT TO COMPROMISE THE MACHINE
STABILITY, KEEP STRICTLY TO THE FOLLOWING
PROCEDURES.
HOLD THE MACHINE DURING THE OPERATIONS
DESCRIBED BELOW.
Remove the machine from the packaging with the
aid of the side carrying handles.
To place the machine in working position, proceed as
follows:
When the machine is in working position:
a) loosen the leg locking pin on the opposite side
of the control unit;
5
b) lift the leg and put it in the wheel support;
c) lock the leg with the relative locking pin;
5 d) tighten the wheel support setscrew;
e) repeat the operation for the other wheel.
CAUTION
IN ORDER TO FACILITATE THE CLASS PLUS
MACHINE MOVEMENT
RECOMMEND LOWERING IT UNTIL THE LOWERED
POSITION.
26
IN THE YARD, WE
a) loosen the leg locking pins on the front side,
one at a time, holding the machine from the
transport handles;
6
b) lower the machine front side, making the legs
slide inside the supports until the leg middle
hole matches the hole of the supports;
c) lock the legs by means of the relevant leg
locking pins;
d) repeat the operations indicated in points (a),
(b), (c) for the rear side.
7 MOVE THE MACHINE.
POSITIONING
Place the machine on a stable surface.
CAUTION
Make sure that:
8
• The motor head is locked by means of the
relevant locking knobs located on the slide
rail
8
• The motor head inclination adjustment lever
is properly tightened.
To place the machine in working position, proceed as
follows:
9
a) Put the leg locking pins in release position.
b) By means of the transport handles, lift one
9
side of the machine until the working position.
CAUTION
For correct machine positioning, make sure that
10
the leg upper hole matches the leg coupling
hole.
Hold the machine during the leg locking phases.
10
c) Lock the legs one at a time.
d) Repeat the operation for the opposite side.
e) Loosen the motor head locking knobs.
11 f) Insert the tube-holder rod in its seat.
g) Insert the tile bearing extension.
12
Battipav srl