Troubleshooting - Battipav CLASSplus 66900 Manual De Instrucciones

Battipav srl

TROUBLESHOOTING

HAVE YOUR TOOL REPAIRED BY A QUALIFIED PERSON
This electric tool complies with the relevant safety rules. Repairs should only be carried out by qualified
persons using original spare parts, otherwise this may result in considerable danger to the user.
Malfunctions not related to a conformity defect that exists at the time of purchase are excluded from the
warranty. Exclusions include:
- Wear of materials (taking into account the average life of the product)
- Failure to comply with the recommendations contained in this manual.
- Maintenance and tampering carried out by unauthorized personnel.
- Use of non-original spare parts.
Faul
The machine does not work.
If lubrication does not arrive at the
disk with the pump running.
Motor gives off unpleasant odour.
Machine is difficult to start.
The machine is cutting out of square.
The laser marker does not work.
Cause
The power supply cable is damaged or
not properly connected.
No voltage in the socket.
Control switch is damaged.
The sprayer unit is clogged.
Water may have seeped through inside
the motor
Motor bearings are damaged.
The tile supports are not at right angles
with the cutting disc.
The disc is not suitable for the type of
material to be cut.
The laser unit is damaged.
The marker feeder is damaged.
Remedy
Press the plug firmly into the power
socket. Check the power supply cable.
Have the socket checked.
Consult local dealer for replacement.
Dismantle the sprayer assembled inside
the disk cover and remove any possible
residuals.
Unplug the power supply cable and
consult local dealer.
Unplug the power supply cable and
consult local dealer.
Using a square, adjust the tile supports
to 90° in relation to the cutting line of
the disc.
Replace the disc with a more suitable
one.
Contact your local dealer for a
replacement.
Contact your local dealer for a
replacement.
GB
31