Joyello JL-1050 SECURFIX BRUUM Manual De Instrucciones página 29

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

GB
re-adjust the support leg.
CHECKLIST
To ensure the optimum safety of your child, check the following after installation:
- Check that the ISOFIX points are securely attached to the vehicle by checking that the indicators
on the ISOFIX points (S) are green (11)!
- Check that the support leg is fully folded out (1), that the lower part of the leg is locked into
position and the indicator on the foot of the support leg is green (12)!
- Check that the car seat base is installed securely and firmly in the vehicle!
REMOVING THE BASE-when attached to the ISOFIX points
Squeeze together the two ISOFIX connection adjustment buttons (R) located on either side of the
support leg at the front of the car seat base and pull the away from the vehicle seat.
Unlock the ISOFIX points (Z) by pulling both Connectors (Q) toward the front of the vehicle seat
(13).
Then pull the car seat base forward on the vehicle seat to release from the vehicle (14).
GROUP 0+ REARWARD FACING(0-13KG)
Firstly you must install the car seat base into your vehicle by using either the seat belt or Installing
the base-with ISOFIX.
You must also ensure that the harness and headrest is set correctly for your child, to do this see
sections "HEADREST AND SAFETY HARNESS ADJUSTMENT"
INSTALLING THE CAR SEAT INTO THE BASE
Firstly make sure that the seat is in its fully reclined position. With the car seat facing towards the
rear of the vehicle, locate the bars on the underside towards the seat into the attachment points on
the base and press the car seat down until you hear a "click" (15 to 16).
Check the seat is secure by lifting the seat upwards.
If the safety indicator remain red, you must release and re-connect the car seat into the base until
the safety indicator be green.
To remove the car seat from the base, press the car seat release button (Y) at the front of the base
while lifting the car seat up from the base (17 to 18).
INSTALLING THE CAR SEAT ONTO THE BASE -GROUP I FORWARD FACING (9kg to 18 kg/
apporx.9 months to 4 years)
WARNING! Child weight below 9 kg cannot use forward facing position
Firstly you must install the car seat base into your vehicle by using either the seat belt or Installing
the base-with ISOFIX. ( See sections )
You must also ensure that the harness and headrest is set correctly for your child, to do this see
sections "Headrest and Safety Harness Adjustment"
29

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Jl-1051 securfix bruum

Tabla de contenido