Eneo VKCD-1323/IR Instrucciones De Manejo página 19

4. Installation
NOTE: Never open the housing by unscrewing the bubble from the upper section of the housing, it is not
possible to correctly reposition the bubble again. The locking bolt also may break off or fall out.
Furthermore, the foam ring, which also protects against scattered light, will be deformed.
NOTE: The upper section of the housing may only be separated from the
lower section by removing the 3 screws (see diagram).
1. Remove dome cover by loosening 3 screws. Use Torx wrench provided with
the package.
2. Surface Mount:
Using four ST4x30 screws, mount surface plate to a sturdy surface.
Using four M4x0 screws, affix flush mount base to surface plate.
3. Flush Mount:
Using four ST4x30 screws, affix flush mount base to a sturdy surface.
1
Torx M4x9
A'
M4x0
2 Surface Mount
A
Plastic dowels
ST4x30
ST4x30
9
3 Flush Mount
ST4x30