Operation; Starting The Unit; Stopping The Unit - Echo DPAS-300 Manual De Instrucciones

Operation

 All over head electrical conductors and communications wires can have electricity flow with high voltages. This unit
is not insulated against electrical current. Never touch wires directly or indirectly, otherwise serious injury or death
may result.
Be particularly careful to observe the following precautions when starting the unit:
 Check that none of the nuts and bolts are loose.
 Leave plenty of space around the product and do not allow people or animals near it.
Failure to observe the precautions could cause an accident or injury, or even lead to a fatality.
 Check that there are no abnormal vibrations or sounds once the unit starts. Do not use the product if there are ab-
normal vibrations or sounds. Contact your dealer to have it repaired.
Accidents involving parts that fall or shatter off can cause wounds or serious injury.
 Always switch off the unit and remove the battery when transporting the unit.
 Never attempt to operate the product with one hand.
 Ensure that you hook your thumbs around the grips, wrapping them in your
thumb and remaining fingers.

Starting the unit

 The attachment will operate when the battery is installed, the power indicator LED is lit, and the trigger switch and
trigger switch lockout are engaged. Make sure the product is properly positioned to prevent loss of control and pos-
sible serious injury.

Stopping the unit

 The attachment continues to run for a short period after the unit is switched off.
Operation
DANGER
WARNING
WARNING
1. Push power button (A) once to turn on power to unit.
 Power indicator LED (B) illuminates when power to unit is
turned on.
2. Hold down trigger switch lockout (C) and depress trigger
switch (D) to increase RPM to operating speed.
 When power to the unit is turned on:
 After one minute of inactivity, unit will power itself off.
 If the LED remains lit, operation is normal.
 If the LED flashes once per second, the battery needs to
be charged.
 If the LED flashes four times per second, there is a fault
within the product. Turn power off to unit. Remove bat-
tery. Clear debris from around line head. Install battery.
Turn power on to unit. If flashing continues, have your au-
thorized servicing dealer repair the product.
WARNING
12
IMPORTANT