Amate Audio Xamp3K Manual De Usuario página 8

Xamp3K
Binding Posts: They accept direct cable connection up to 8mm
The Binding Posts are marked with Red for the Positive Pole, and Black for the
Negative Pole. Separate outputs are available for each channel: 2 binding Post
(RED/BLACK) for LOW and 2 binding Post (RED/BLACK) for HIGH. This connector
is connected in parallel mode with the Speakon OUT.
The outputs are configured as following:
Binding
Table 2. Configuration of loudspeaker connections
WARNING: high risk of malfunction or major damage!
As specified in the previous point, there is the possibility to use
simultaneously the different outputs, such as OUT SPEAKON, LINK
SPEAKON and the Binding Posts. Please make sure to check that the
total load connected to each channel is not below 4 Ohm, since all outputs are
connected in parallel.
Be extremely careful when performing the connections, as a short-circuit between
any of the positive pins (+1, +2) can damage the amplifier or even cause the
destruction of one or both power modules.
4.3 Connection of the inputs/auxiliary outputs
The inputs (BALANCED INPUTS) enable connection through XLR-3 connectors. The
amplifier incorporates balanced inputs for a high rejection of noise generated by long
signal cables, proximity to electric wires or sources causing them.
BALANCED Inputs/auxiliary outputs:
1. Shield
2. (+) Live
3. (–) Return
UNBALANCED Inputs/auxiliary outputs:
1. Not connected (* See Note)
2. (+) Live
3. Ground
8
Output
Positive
OUT
Negative
Positive
Post
Negative
Positive
LINK
Negative
LOW HIGH
+1 +2
-1 -2
LOW HIGH
(RED) (RED)
LOW HIGH
(BLACK) (BLACK)
+1 +2
-1 -2
Input
Link
May 2016
2
section (8AWG).
Amate Audio