Cleaning And Maintenance - Clatronic BSR 1282 Instrucciones De Servicio

Робот - пылесос CLATRONIC BSR 1282
Купить в интернет-магазине http://clatronic-shop.com.ua

Cleaning and Maintenance

WARNING:
• Always disconnect the device from the power adaptor
before cleaning!
• Do not submerge the device in water. Only the dust
container and the filter can be rinsed off.
CAUTION:
• Do not use a wire brush or other abrasives for cleaning.
• Do not use aggressive or abrasive cleaning agents.
Clean the casing with a dry cloth.
Ensure before and after each use that the nozzle and the ven-
tilation openings are clean. For best performance, you should
empty the dust container and clean the filter after every use.
Empty the Dust Container and Clean the Filter
CAUTION:
• Replace all parts only when they are completely dry!
• Do not wash the filters in the washing machine and do not
use a hair dryer.
NOTE:
Use a brush to clean the filter.
1. Press the two unlock buttons (3) of the dust container
down to loosen the dust container.
2. Lift the dust container out of the appliance. (Fig. D)
3. Carefully remove the dust container cover. Slightly pull
one of the locks on the side slightly away from the dust
container to unlock the cover. (Fig. E)
4. Hold the dust container over a dustbin and remove the
filter. (Fig. F)
5. Empty the container into the dustbin and carefully beat or
brush off the filter.
6. Both components can be cleaned under running water.
They must be completely dry before being replaced.
32
7. Brush out the container compartment in the appliance
before replacing the dust container. Turn the appliance
upside down and brush off the nozzles and the bottom of
the appliance. Wipe the casing with a dry or slightly damp
cloth.
8. Replace the filter in the dust container (the plastic grid must
be aligned upward).
9. Replace the dust container in the appliance so that it clicks
into place.
Clean/Replace/Attach the Floor Cloth
Over time, dirt can collect on the floor cloth. You can clean or
replace the floor cloth.
1. Turn the appliance upside down and place it on the floor or
on a table.
2. The floor cloth is attached to a plastic holder (16). It is
attached to the appliance on the left and right sides next
to the drive wheels (14) and (17). Take the narrow end
piece of the holder between your fingers and pull it outward
towards the drive wheel until it comes free. Now you can
remove the holder from the appliance. (Fig. G)
3. Turn the holder around and pull the cloth out of the 4 clips.
4. Now you can wash it in lukewarm water and a mild
detergent. The supplied cloths are not suitable for the
washing machine! Leave the cloth to dry completely
before using it again.
5. Dispose of the cloth after it is worn and use a new one.
Place it in the holder and press the ends into the 4 clips.
(Fig. H)
6. Press the holder into the interlocks at the bottom of the
appliance and check for proper fit.
NOTE:
• You can also use commercially available cloths as a floor
cloth.
• A screwdriver is supplied for easy attachment of the floor
cloth.