Publicidad
Idiomas disponibles
Idiomas disponibles
__,dmh.
_
_m_m_,_mF__
®
MODELS QP1308L.QP1308LC.QP130SS.QP130SSC
QP130WW * QP130WWC * QP138BL * QP138SS * QP138WW
Page 4
CENTER
RETAINING SCREW
RECIRCULATION
i"
SLIDE PLATE
OUTER
RETAINING SCREWS
\
El
El
NON-DUCTED
INSTALLATION
ONLY:
Remove Center Retaining Screw and loosen Outer
Retaining
Screws holding Recirculation
Slide Plate
in place. Pull out slide plate and replace and tighten
retaining screws to hold slide plate in new (non-ducted)
position.
NON-DUCTED
INSTALLATION
ONLY:
Purchase a set of (2) non-ducted filters from your local
distributor or retailer. Attach the non-ducted filters to the
aluminum mesh filters following instructions packed with
the non-ducted filters.
FOR NON-DUCTED INSTALLATIONS =Skip to "INSTALL
THE HOOD':
7" ROUND
KNOCKOUT
PLATE (also
remove 3W' x 10"
vertical plate)
E]
./>
_
31A'' X 10"
VERTICAL
KNOCKOUT
3W' X 10"
PLATE
KNOCKOUT
PLATE
DUCTED iNSTALLATION
ONLY:
Remove 3_A" x 10 vertical, 3_A" x 10" horizontal, or 7-inch
round knockout
plate(s) as appropriate for your ducting
method.
o
CONNECTOR
7" ROUND
DUCT
PLATE
DUCTED INSTALLATION
ONLY:
Attach 31,_ '' × 10" Damper/Duct
Connector
(if using 3_ ''
x 10" duct) or 7" Round Duct Plate (if using 7-inch round
duct) over the knockout opening.
Note:
To accomodate off-center ductwork, the 3W'x 10" damper/
duct connector can be installed up to _/2" on either side
of the hood center and the 7" round duct plate can be
installed up to 1/2" on either side of the hood center.
Trim the flange on the duct connector or duct plate if it
interferes with the electrical cable clamp.
Install the 3W'x 10" Damper/Duct Connector with the
Damper Flap Pivot nearest the Top/Back Edge of Hood.
INSTALL
THE HOOD
4_lb
WARNING
To reduce the risk of electrical shock, switch power off
at service panel. Lock or tag service panel to prevent
power from being switched on accidentally.
ELECTRICAL
WIRING BOX
COVER
ELECTRICAL
POWER
CABLE KNOCKOUT
El
Remove Electrical
Wiring Box Cover from inside
of hood and appropriate Electrical
Power Cable
Knockout
from top or back of hood.
Publicidad
