Box Contents - TIGEX Simplici’T + Instrucciones De Uso

GB
1. INTRODUCTION
Thank you for choosing the Tigex video baby alarm. This device is a wireless electronic communication
system which enables you to monitor your baby while he or she is sleeping. This device must only be
used to assist you; it must never replace an adult, a baby-sitter or a care professional.

2. BOX CONTENTS

1 baby unit (emitter) – mains power only
1 parent unit (receiver) – mains or rechargeable battery powered; the unit comes with a "battery re-
charge" function
2 power adapters enabling both units to be connected to mains power
1 rechargeable battery for the parent unit
1 set of operating instructions
3. INSTALLATION
Parent unit:
Mains power: connect one of the two power adapters supplied into the left hand side of the parent unit
in the socket marked "DC 5V" and connect the power adapter into a standard 230V plug socket. The
parent unit is now ready for use.
Rechargeable battery power: if you wish to use the parent unit wirelessly, slide the battery cover on
the parent unit back and insert the rechargeable battery supplied. The battery can only be inserted one
way, so do not try to force it if it does not fit.
To recharge the battery, connect on of the two power adapters supplied into the left hand side of the
parent unit in the socket marked "DC 5V" and connect the power adapter into a standard 230V plug
socket. You will need to charge the battery for at least 24 hours before the first use.
Note: the parent unit comes with a belt clip which enables you to carry and use the unit in "hands-free"
mode.
Baby unit:
Mains power only: connect one of the two power adapters supplied into the right hand side of the baby
unit in the socket marked "DC 5V" and connect the other end into a standard 230V plug socket. The
baby unit is now ready for use.
Positioning:
Place the baby unit around 2 meters from the baby.
ENSURE THAT THE BABY IS NOT ABLE TO TOUCH THE POWER CABLE. ALSO ENSURE THAT THE UNIT
CANNOT FALL INTO THE COT.
C
Do not place the baby unit or parent unit in direct sunlight or in a damp environment. The baby alarm
is not water-proof. An atmosphere with excessive humidity may damage the electronic components.
4. USE
«On» light
Switching on both units:
Screen
C
Press the
button down until the "on" light switches on, after around
Button
three seconds on the baby unit or until the screen lights up on the pa-
22