Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
If you are using controllers with this occupation, you can connect the DMX-output of the controller directly
with the DMX-input of the first device in the DMX-chain. If you wish to connect DMX-controllers with other
XLR-outputs, you need to use adapter-cables.
Building a serial DMX-chain:
Connect the DMX-output of the first device in the DMX-chain with the DMX-input of the next device. Always
connect one output with the input of the next device until all devices are connected.
Caution: At the last device, the DMX-cable has to be terminated with a terminator. Solder a 120
between Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last device.
5.6 Addressing
Each device occupies 1 or 4 channels, respectively. To ensure that the control signals are properly directed
to each device, the device requires adressing. This is to be done for every single device by changing the DIP
switches as set out in this table.
The starting address is defined as the first channel from which the device will respond to the controller.
Please make sure that you don't have any overlapping channels in order to control each device correctly and
independently from any other device on the DMX data link. If two, three or more device are addressed
similarly, they will work similarly.
Occupation of the DIP-switches:
Setting the DMX-
1
DIP-switch no.
starting address:
Device number
1
Starting address
& channels
On
Device 1 - channel 1
Off
Off
On
Device 2 - channel 2
Off
On
Device 3 - channel 3
Off
On
Device 4 - channel 4
Off
On
Device 5 - channel 5
Off
This device can be defined as a 4-channel dimmer pack (normal DMX) or as with one address for all 4
channels (DMX parallel).
Please adjust your selection via DIP-switch no. 10.
DIP-switch 1: one address
DIP-switch 0: 4 channels
DMX ADDRESS
Function
6. OPERATION
After you connected the device to the mains and switched the main circuit breaker, the ESX-4 is ready for
use.
You can control the desired channel via you lighting controller. When a DMX-controller and an analog
controller is connected, the device reacts to the stronger signal.
2
3
4
5
6
7
8
2
4
8
16
32
64 128 256
1
any one of DIP switch 1-9 is on, DMX parallel
All of DIP switch 1-9 is off, auto parallel
any one of DIP switch 1-9 is on ,DMX
Setting the DMX-
9
DIP-switch no.
starting address:
Projector number
DMX-starting
& channels
address
Device 1 - channels 1-4
Device 2 - channels 5-8
Device 3 - channels 9-12
Device 4 - channels 13-16
Device 5 - channels 17-20
FUNCTION
2
3
4
5
6
7
8
All of DIP switch 1-9 is off , Auto
16/31
1
2
3
4
5
6
1
2
4
8
16
32
On
Off
Off
On
Off
On
Off
On
Off
On
Off
9
10
1
0
70064222X87NXS_V_1_0.DOC
Ω
resistor
7
8
9
64 128 256
Publicidad
Tabla de contenido
