Auto Tuning; Manual Tuning; Recalling Preset Stations - Denon AVR-1603 Instrucciones De Operación

ENGLISH

Auto tuning

1 2 4
1
4
3
2

Manual tuning

1 Set the input source to "TUNER".
2
Watching the display, press the BAND button to
select the desired band (AM or FM).
NOTE:
• When the manual tuning mode is set, FM stereo broadcasts are received in monaural and the "STEREO" indicator
turns off.
24
1 Set the input source to "TUNER".
(Main unit) (Remote control unit)
2
Watching the display, press the BAND button to
select the desired band (AM or FM).
(Main unit) (Remote control unit)
3
Press the MODE button to set the auto tuning
mode.
Lit
(Remote cont ol unit)
4 Press the TUNING UP or DOWN button.
(Main unit) (Remote control unit)
• Automatic searching begins, then stops when
a station is tuned in.
NOTE:
• When in the auto tuning mode on the FM band, the
"STEREO" indicator lights on the display when a
stereo broadcast is tuned in. At open frequencies,
the noise is muted and the "TUNED" and "STEREO"
indicators turn off.
3 Press the MODE button to set the manual tuning
mode.
Check that the display's "AUTO" indicator turns
off.
4
Press the TUNING UP or DOWN button to tune
in the desired station.
The frequency changes continuously when the
button is held in.
Preset stations
2 3
3
2
1, 4

Recalling preset stations

1 2
2
1
Preparations:
Use the "Auto tuning" or "Manual tuning" operation
to tune in the station to be preset in the memory.
1 Press the MEMORY button.
(Remote cont ol unit)
2
Press the SHIFT button and select the desired
memory block (A to E).
(Main unit) (Remote control unit)
NOTE: Please make sure the "AUDIO" position
of the slide switch on the remote control
unit.
3
Press the PRESET UP or DOWN button to select
the desired preset channel (1 to 8).
(Main unit) (Remote control unit)
4 Press the MEMORY button
again to store the station in
the preset memory.
(Remote cont ol unit)
To preset other channels, repeat steps 1 to 4.
A total of 40 broadcast stations can be preset – 8
stations (channels 1 to 8) in each of blocks A to E.
1
Watching the display, press the SHIFT button to
select the preset memory block.
(Main unit) (Remote control unit)
NOTE: Please make sure the "AUDIO" position
of the slide switch on the remote control
unit.
2
Watching the display, press the PRESET UP or
DOWN button to select the desired preset channel.
(Main unit) (Remote control unit)