Publicidad
Idiomas disponibles
Idiomas disponibles
,_
WARNING: TO AVOIDSERIOUSINJURY,BEFOREPERFORMINGANY SERVICEOR
ADJUSTMENTS:
, Depress clutch/brake pedal fully and set parking brake.
, Place attachment clutch in "DISENGAGED" position.
4. Turn ignition key to "STOP" and remove key.
5. Make sure the blades and all moving parts have completely stopped.
6. Disconnect spark plug wire from spark plug and place wire where it cannot come
in contact with plug.
TO REMOVE MOWER
1. Place attachment clutch in "DISEN-
GAGED" position.
2, Lower attachment lift to lowest position.
3, Disengage belttension rod (K) from lock
bracket (L).
Ai_CAUTION: Rod is spring loaded. Have a
tight grip on rod and release slowly,
4. Remove mower belt from electric clutch
pulley (M)."
5, Disconnect front link (E) from mower -
remove retainer spring and washer,
6. Go to either side of mower and discon-
nect mower suspension arm (A) from
chassis and rear lift link (C) from rear
mower bracket (D) - remove retainer
springs and washers,
7. Go to otherside of mower and disconnect
the suspension arm and rear lift link.
_l_ CAUTION; After rear liftlinks are discon-
nected, the attachment liftlever will be spring
loaded, Have a tight grip on lift lever when
changing position of the lever,
8. From right side of mower, disconnect
anti-sway bar (S) from right rear mower
bracket (D) - remove retainer spring and
washer and pull mower toward you until
the bar falls from the hole in bracket.
9, Turn tractor steering wheel to the left as
far as it wig go.
10. Slide mower out from under right side of
tractor.
TO INSTALL MOWER
Follow procedure described in"TO INSTALL
MOWER" in the Assembly section of this
manual.
26
Publicidad
