Limit Switches - GF EA 04 Manual Instrucciones

Installation
 In addition to these instruction manual, also follow manufacturer's specifications
on ball valve type 546.
 Before installation, compare technical data of the actuator with the control and the
valve. Only install actuator if the data matches.
 Before installation, check plugs and terminals for possible damage.
 Make sure that no damaged parts are used.
 Have installation and assembly only carried out by specialist staff.
 If device is directly controlled:
- Fit a circuit breaker on site.
- Do not connect grounding conductor.
Requirements
- Cross section of the power lines max. 1.5 mm
- Fuse size: > 6 A.
 Ensure that actuator is only connected to voltages that meet the requirements on
a protective extra low voltage circuit (PEVL).
 Connect actuator, see Section 7.1 Connection diagram

7.3 Limit switches

The two end positions in the actuator have been factory set to 90°.
36
Electrical actuator type EA04
2 .