Functional Description - Empire eLGC Manual Del Operador

SYMBOLOGY
Volts
Direct Current
To reduce the risk of injury, user must
read operator's manual.
European Conformity Mark

FUNCTIONAL DESCRIPTION

1. Laser aperture
2. On/Off switch
3. Magnets (not shown)
4. Integrated mount
5. Battery compartment
6. Threaded insert
(not shown)
1
6
ASSEMBLY
Changing the Battery
Only use alkaline batteries. Do not use zinc-carbon
batteries. If the laser will not be used for a long
time, remove the batteries as a protection against
corrosion.
Change batteries when the battery indication begins
flashing. To change the batteries:
1. Lift latch to open battery door.
2. Insert four AA batteries according to the +/- polarity
marked in the compartment.
3. Install the battery door securely.
Low Battery Indication
To indicate low battery (about 30 minutes of battery
life remaining*), the laser lines will flash:
• In ON - 3 times every 4 seconds
ON - 3 times every 8 seconds
• In
The low battery indicator flashing will continue until
the batteries are removed and replaced.
During self-leveling, the out-of-level indicator (flash-
ing 3 times per second) will override the low battery
indictor.
*Battery life may vary by brand/age. Replace the
batteries as soon as possible.
LASER RADIATION
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
2
3
4
5
OPERATION
To reduce the risk of injury or tem-
WARNING
porary effects on vision, do not
look directly into the laser when it is on.
Use of controls or adjustments or
CAUTION
performance of procedures other
than those specified herein may result in hazard-
ous radiation exposure.
Perform the Accuracy Field Check
NOTICE
procedure immediately upon unboxing
of each new Laser Level and before exposure to
jobsite conditions. See "Accuracy Field Check"
for information.
Turning On/Off
To turn on the laser and unlock the pendulum, slide
the switch to the desired position. Two perpendicular
lines will immediately be emitted from apertures.
WARNING! Do not look directly into laser apertures.
ON Turns ON the laser and unlocks the pendu-
lum to enable self-leveling.
ON Turns ON the laser but does not unlock the
pendulum (self leveling is disabled). The
laser lines will flash once every 8 seconds
to indicate that the projected lines are not
level or plumb.
NOTICE The
leveling and therefore is not intended for
projecting a level or plumb line.
OFF Turns OFF the laser and locks the pen-
dulum. When not in use, turn off the tool
and store the Laser Level in the protective
carrying case.
Using the Laser Level
1. For best results, place the tool on a work surface
that is:
• sturdy
• level (within 4 degrees of true level)
• free of vibrations
2. Turn on the tool.
3. In ON mode, the tool will self-level when placed
on surfaces within 4 degrees of true level.
4. The tool is ready once the emitted lines are con-
tinuous and no longer moving on the work surface.
5. If the tool cannot achieve a level state (i.e., the
work surface is > 4 degrees off true level), the laser
points will flash rapidly (3 flashes per second).
Relocate or adjust the work surface.
Troubleshooting
If the tool does not turn on:
• Ensure batteries are inserted correctly according to
the +/- polarity marked in the compartment.
• Replace batteries that may be at the end of life.
• Ensure the tool's internal temperature is within
specified operating ranges. If stored in excessive
heat or cold, allow at least 2 hours to acclimate to
ambient temperature before turning on the tool.
• Ensure the switch is in the
If problem persists, please contact Empire Level
Customer Service for support.
3
ON mode disables self-
ON position.