Installation - Alpine DVA-9860 Manual De Uso

Installation

Caution
Do not block the unit's fan or heat sink, thus preventing air
circulation. If blocked, heat will accumulate inside the unit and
may cause a fire.
Air ventilation hole
(Rear side)
1
No Pressure Here
No Pressure Here
Remove the Detachable Front Panel (refer to page 8).
Slide mounting sleeve from main unit. (see "Removal"
on this page).
Slide the mounting sleeve into the dashboard.
NOTE
Please examine the installation. Make certain that no external
pressure is applied to either the top of the unit or the removable
nosepiece.
2
Hex Nut (M5)
Metal
Mounting
Strap
Ground Lead
Reinforce the head unit with the metal mounting strap
(not supplied). Secure the ground lead of the unit to a
clean metal spot using a screw (*) already attached to
the vehicle's chassis.
NOTE
For the screw marked **, use an appropriate screw for the
chosen mounting location.
Connect each input lead coming from an amplifier or
equalizer to the corresponding output lead coming from
the left rear of the DVA-9860. Connect all other leads of
the DVA-9860 according to details described in the
CONNECTlONS section.
Mounting Sleeve
(Included)
Dashboard
This unit
Screw
∗∗
Bolt Stud
∗
This unit
Chassis
3
Slide the DVA-9860 into the dashboard until it clicks. This
ensures that the unit is properly locked and will not
accidentally come out from the dashboard. Install the
Detachable Front Panel.
Removal
1 Remove the DETACHABLE FRONT PANEL.
2 Insert the bracket keys into the slot and through the
guides on either side of the unit. The unit can now be
removed from the mounting sleeve.
This unit
3 Pull the unit out, keeping it unlocked as you do so.
<JAPANESE CAR>
This unit
Ground Lead
∗
NOTE
Secure the ground lead of the unit to a clean metal spot using a screw
∗
( ) already attached to the vehicle's chassis.
Bracket keys
(Included)
Face Plate
Screws (M5 × 8)
(Included)
Mounting Bracket
55
-EN