Setting For Working At A Tilt; Working With The Parallel Stop; Working With The Roller Edge Guide; Grooves With F-Guide Rail - Mafell NFU 50 Manual De Instrucciones Original

Follow the procedure below:

Set the machine to the desired milling depth.

Open the clamping lever 14 (Fig. 2) and set the
stop bar 16 downwards to the limit stop.

Retighten the fastening lever 14 (Fig. 2).
At low milling depths, you must
position the repeater depth stop
adapter 52 (Fig. 2) underneath the
stop bar 16.

5.5 Setting for working at a tilt

The milling unit can be set to any angle between 0°
and 45° for both tilted milling and notch milling work.

In order to incline it, bring the machine into
home position and support it such that it is
possible to tilt the milling unit.

Unfasten the clamping lever 10 (Fig. 2).

Adjust the angle according to the scale on the
swivel segment.

Retighten the clamping lever 10.
We provide a calculation tool for
calculating the milling depth. You
can access this tool via the QR
code on the machine or the website
specified on the label.

5.6 Working with the parallel stop

The parallel stop 18 (Fig. 6) is used to work parallel to
an already existing edge. The limit stop can be
attached to the left or right of the machine.

You can adjust the milling position after
unfastening the wing screws 9 (Fig. 1) by
moving the limit stop accordingly and afterwards
retightening the wing screws.
In addition, the parallel stop can be guided along a
lath that is fastened on the workpiece.

5.7 Working with the roller edge guide

The roller edge guide 20 (Fig. 6) is used to work
parallel to an already existing edge. The limit stop can
be attached to the left side of the machine.

You can adjust the milling position after
unfastening the wing screws 9 (Fig. 1) by
moving the limit stop accordingly and afterwards
retightening the wing screws.
Now the machine can be guided along a narrow
workpiece running below the base plate.

5.8 Grooves with F-guide rail

Setting the desired milling depth according to chapter
5.3.
Carry out groove milling using an
F-guide rail. Wider grooves are
achieved by laterally offsetting the
guiding device from the right to the
left.

5.9 Working with the guide rail

It is recommended to use the guide rails (see Chapter
8, Optional accessories) with the adapter pair for
machining notches.
Follow the procedure below:

Attach the parallel stop 18 (Fig. 6) to the
machine.

Mount the adapter pairs 60 (Fig. 9) in the
positions ZZ (Fig. 6) intended for this purpose.

Hook the adapter pairs into the guide rail
attached parallel to the milling groove.

Set the machine to an inclination and depth as
described under 4.4 and 4.5

Move the milling cutter across the parallel stop
bars to the desired position.

Tighten the screws 9 (Fig. 1).
-27-