Switching On And Using The Pump; Operating Mode; Regulating Modes - DAB E.SWIM Instrucciones De Instalación Y Mantenimiento

If you need to revise all these parameters quickly at a later date, you can reload the WIZARD by
selecting a specific item on the menu (paragraphs 6.2 and 6.2.1.1).
The WIZARD presents the following pages in sequence:
1. Select Language (see also par. 6.2.1.2)
2. Select time display mode (24h or am/pm)
3. Set current time
4. Set current day
5. Set Unit of measure of head
6. Set Unit of measure of flow
7. Set Unit of measure of temperature
8. Selecting Regulating Mode
9. Select maximum limit of flow (Qmax) (see also par. 6.2.1.5)
10. Select maximum limit of head (Hmax)
11. Final confirmation
Each page of the Wizard presents a single parameter to configure, starting from the language.
Title
Keys to use
(the arrows are not shown)
As well as the title, the page shows these indications:

symbol "1/11": indicates the current page number (1), out of the total pages of the WIZARD (11), and of
course it changes from one page to the next;

in the centre of the page is the list (or menu) of the various languages available, and the box shows the
language currently selected;

the vertical bar, represented on the left, shows the position where we are on the list (or menu) of the
languages available; in the example, we are in the first position and the sign on the bar is at the top;

the keys to use are indicated at the bottom (as well as the arrows which, for simplicity, are not shown):
"OK" key [
o
"ESC" key [
o
made, it returns to the previous page.
As is intuitive, use the up arrow and down arrow keys to scroll through the list of languages to select the one you want,
then press "OK" [
WIZARD.
On some pages, such as the one with hours and minutes, the arrows also allow you to change the value displayed.
After having chosen the units of measure and, if necessary, set the limits of the flow rate and head, a page is shown
telling you that the Wizard is complete. By pressing "ESC" you can go back to review or change the settings; by
pressing "OK" you leave the Wizard and proceed to normal pump operation.

5 SWITCHING ON AND USING THE PUMP

5.1 Operating mode

5.1.1 Regulating modes

The following diagram shows the indicative curves of the system's hydraulic performances.
]: confirms any changes made and allows you to proceed to the next page;
]: cancels any changes made; when you press it again, or if no changes have been
]. The selected language is activated and you proceed to the next page (number 2/11) of the
ENGLISH
Figure 10
43
Page in the Wizard
(this is page 1 of a total of 11 pages)