Safety Information - Invacare H450LA Omega Manual Del Usuario

Invacare® H450LA Omega
1471013 (Fig. 2)
The retrofit kit 1471013 is already assembled in the
scope of delivery of H450LA.
F Adjustable tube (4x)
Height adjustment clip (4x)
G
Guide bushing (4x)
H
Service life
The expected service life of this product is three years when
used in accordance with safety instructions and intended
use, stated in this manual. The effective service life can vary
according to frequency and intensity of use.
Safety

Safety information

WARNING!
Risk of injury!
– Do not use if defective.
– Do not use in the shower (Fig. 10).
– Keep product away from open flames.
– Do not place smoldering cigarettes on the
product.
– Only use spare parts and accessories intended
for this product.
– Do not make any unauthorized alterations or
modifications to the product.
WARNING!
Risk of falling!
– Do not stand on this product.
– Do not use as a climbing aid.
– Do not lift the product at the armrest for
re-positioning or transfer while seated.
– Do not pull/push the chair to displace it under
load.
WARNING!
Risk of burning your skin!
The product components can heat up when
exposed to external sources of heat.
– Do not expose the product to strong sunlight
before use.
Symbols on the product (Fig. 3)
The identification label is located on the bottom of the seat.
Manufacturer address
A
B This product complies with Directive 93/42/EEC
concerning medical devices. The launch date of this
product is stated in the CE declaration of conformity.
Only use on flat surfaces
C
D Lot number
Read user manual
E
Maximum user weight
F
G Date of manufacture
Product designation
H
4
Assembly
Toilet seat (Fig. 4)
1. Attach the toilet seat A with the clips B to the rear
frame tube C.
CAUTION!
– Make sure that both clips engage with an
audible click.
– Make sure that both clips are placed between
the stop screws D and not on top of the stop
screws.
Seat cover plate (Fig. 5)
1. If desired, insert the seat cover plate E from above into
the toilet seat opening.
IMPORTANT!
– Make sure that both stoppers F on the
underside of the seat plate engage into the
opening G of the toilet seat.
Adjustable leg tubes (Fig. 6) (Retrofit kit 1471013)
1. Remove cap A from the frame tube B.
2. Remove rubber tip C from the end of the frame tube.
3. Insert guide bushing D into the frame tube.
4. Push the adjustable tube E over the frame tube.
5. Position the adjustable tube to the desired height.
6. Insert the height adjustment clip F into the holes of the
adjustment tube and frame tube.
WARNING!
Risk of injury
– Make sure that the clip fully engages through
both holes with an audible click.
7. Repeat the same steps for the remaining three legs.
WARNING!
Risk of injury
– Make sure that all legs are adjusted to the same
height (Fig. 9).
Usage
Adjusting the height of the legs (Fig. 8)
1. Remove the height adjustment clip A from the holes of
the adjustment tube B and frame tube C.
2. Position the adjustable tube to the desired height.
3. Re-insert the height adjustment clip into the holes of the
adjustment tube and frame tube.
WARNING!
Risk of injury
– Make sure that the clip fully engages through
both holes with an audible click.
4. Repeat the same steps for the remaining three legs.
WARNING!
Risk of injury
– Make sure that all legs are adjusted to the same
height (Fig. 9).
Inserting/Removing the toilet pan (Fig. 7)
The toilet pan A can be inserted/removed with or
without cover B.
1. Insert the upper rim of the toilet pan A from the side
between the toilet seat D and the brackets C under
the seat.
1471169-A