One Person - Clarke American Sanders 07104A Manual Del Operador

ENGLISH
EN
How to Transport the Machine
4. To store the dolly in the "UP" position, swing the
dolly up against the top of the mainframe as far as it
will travel and close the quick release levers to
secure it in place. (See Figure 5)
5. To remove the dolly, loosen the quick release
adjustment nuts until the levers and nuts clear the
counter-bore on the dolly brackets, and remove the
dolly.
6. Tighten the adjustment nuts until the quick release
levers can be closed to secure the dolly in place.
Transporting the Machine - One Person
NOTE: This is accomplished by removing the motor
from the chassis and transporting the motor and chassis
separately.
To transport the machine, follow this procedure:
1. Make sure the power cable is disconnected from the
electrical outlet.
2. Release the tension on the drive belts using the
quick release lever. (See Figure 6A )
3. Open the belt guard by pulling on the handle immedi-
ately above the left truck wheel. (See Figure 6B)
4. Remove the drive belts from the machine
5. Disconnect the motor pigtail from the handle pigtail.
(See Figure 7) if so equipped.
6. Unscrew the motor mounting knobs to loosen the
motor. (See Figure 8)
7. Straddle the motor and grasp the motor lift handle.
Using your legs, lift the motor off the chassis and
take it to the work site.
8. Lift the chassis by grasping the front and rear
handles. Lift the frame and bring the belt guard
against your chest. Take the chassis to the work
site.
To assemble the machine after transporting, follow this
procedure:
1. Open the belt guard door. Place the motor assem-
bly on the chassis and screw the motor mounting
knobs sufficiently to engage and secure the motor.
2. Install the drive belts. Tighten the belts using the
belt tension quick release lever.
3. Check the tension on the belts and close the belt
guard door.
-8-
A
Clarke ® American Sanders
Figure 5
Figure 6
Figure 7
Figure 8
Operator's Manual (EN) - Floorcrafter
B