230V Electrical Connection Instructions - Clarke American Sanders 07104A Manual Del Operador

ENGLISH
EN

230V Electrical Connection Instructions

CAUTION: This machine will operate only on
AC frequency and on electrical volt-
age shown on the equipment
nameplate. Make sure you have
the correct frequency and voltage
before connecting the power cord
to an outlet. See the example in
figure 1.
This machine must be connected to an electrical source
with an earthing conductor in order to protect the operator
from electric shock. This machine has an approved
power cord with three conductors as well as a plug with
three terminals. Connect the plug to a matching recep-
tacle.
DANGER: Electrocution could occur if the
machine is exposed to water or
rain. Keep the machine in a dry
building.
DANGER: Electrocution could occur if ma-
chine is not connected to an elec-
trical source with an earthing con-
ductor. To prevent possible elec-
tric shock, use an electrical cord
with an earthing conductor and
connect it to a matching electrical
source. For maximum protection
against electrical shock, use a cir-
cuit that is protected by a ground
fault circuit interrupter. Consult
your electrical contractor.
DANGER: Electrocution could occur if the
machine is used with a damaged
plug or power cord. If the cords or
plugs are worn or damaged in any
way, have them replaced by an
authorized service person or elec-
trician.
Extension Cords
Use only an approved three-pronged extension cord with
two main conductors and one earthing conductor. This
machine is equipped with a power cord. When greater
range is needed follow the table below to determine cable
gauge of additional footage. Refer to the chart to the right
for extension cord information.
If motor appears to labor or takes a considerable longer
time to come up to speed reduce sanding pressure.
-6-
Feet/Wire Guage (Stranded Copper)
Source Voltage
208
230
Clarke ® American Sanders
Figure 1
0 - 100' 100 - 250'
Use Voltage
6
Booster
10
Operator's Manual (EN) - Floorcrafter
8