DeWalt DW744 Manual De Instrucciones página 5

FIG. 3
TABLE
SCREW-DOWN
HOLES
MITER
GAUGE
MOUNTING
HOLES
FIG. 4
BLADE GUARD
WORK SUPPORT
EXTENSION
(RETRACTED)
BLADE/WRENCH
STORAGE
RIP SCALE INDICATOR
ON-OFF SWITCH
ANTI-KICKBACK TEETH
DUST EXHAUST
3
Specifications
Horsepower
Table Size
Miter Angle
Bevel Angle
Blade Size
Max. Cut Depth
Max. Cut Depth
RAIL LOCK
RPM, no load
LEVER
Unpacking
Open the box and slide the saw out , as shown in Figure 1.
FINE ADJUST
Carefully unpack the table saw and all loose items from the
KNOB
carton. Examine all parts to make sure that parts have not
been damaged during shipping. If any parts are missing or
damaged, contact your dealer to replace them before
attempting to assemble the tool.
BLADE HEIGHT
Figure 2 shows all the loose items and hardware packed with
ADJUSTMENT
WHEEL
the saw.
1. Rip fence
2. Blade (attached to saw base)
3. Arbor wrench and spindle wrench (attached to saw
base)
BEVEL LOCK
4. Blade guard
LEVER
5. Throat plate
6. Miter gauge
Examine Figures 3 & 4 to become familiar with the saw and
its various parts. The following sections on assembly and
adjustments will refer to these terms and you must know
what and where the parts are.
Assembly
YOUR SAW SHOULD BE ASSEMBLED IN THE
FOLLOWING ORDER:
1. Blade
2. Rip fence (NOTE: Adjust rip scale before proceeding.
See "Adjusting Rip Scale".)
3. Blade guard
4. Throat plate
FIG. 5
RIP FENCE
LATCH
2-1/2
19 1/4" x 26 1/2"
30° L&R
0° to 45°L
10" (254mm)
0° Bevel ................3 1/8" (79mm)
45° Bevel ..............2-1/4" (57mm)
3650
PIN
OPENING