Promax 10 premium Guía De Usuario página 79

USER'S MANUAL. PROMAX-10
When pressing again on the
rotary knob [9] the field level of
reference will be selected. It is the
maximum level of the vertical axis of the chart. By
turning the rotary knob [9] clockwise it will increase
and if you turn anti-clockwise it will decrease.
To change the tune, press again the
rotary knob [9]. The field Channel will be
activated again. Turning the rotary knob will be
possible to change its value.
The attached figure shows a horizontal line
at 45 dBµV. This line
judgements of channel level acceptance easily. To
activate and define this reference line, you should
see the SCAN configuration menu (section 4.2.2.1).
In the case of having activated the
broadband power detection function (POWER
MEAS -> ∑PWR) in the configuration menu of
SCAN mode (See section 4.2.2.1), on the display of
PROMAX-10 Premium will appear the total power
level on the instrument RF input. See the attached
figure.
This parameter indicates the total power
that is being transmitted by the connected coaxial
cable to the PROMAX-10 Premium
5 to 863 MHz.
The SCAN operating mode also allows channels to be programmed for use as
pilots in TILT operating mode, in the forward band (see section 4.2.5 TILT operating
mode).
In the SCAN operating mode, all channels are considered as analogue. When the
power of a digital channel is measured in this mode, the instrument does not
carry out the integration of the power values, but it just measures at the central
frequency of the digital channel. Then, the resulting value is not calibrated and is
6 or 7 dB lower than the measurement made in the CHANNEL-FREQUENCY mode,
which does the power integration.
11/2008
Premium
Figure 10.- SCAN mode, Ref. 90 dB
allows establishing
in the band from
µ
V.
Figure 11.- SCAN mode with
reference line at 45 dBµV.
Figure 12.- SCAN mode, power
detection function.
IMPORTANT
Page 19