Publicidad
8. TROUBLE SHOOTING
WARNING! Only perform the steps described within these
instructions! All further inspection, maintenance and repair work
must be performed by an authorised service centre or a similarly quali ed
specialist if you cannot solve the problem yourself!
Problem
Possible cause
Not connected to power supply
Product does
Power cord or plug is defective
not start
Other electrical defect to the product
Extension cord not suitable for
operation with this product
Product does
Power source (e.g. generator) has
not reach full
too low voltage
power
Air vents are blocked
Sanding sheet is worn
Unsatisfactory
result
Sanding sheet not suitable for work
piece material
9. PROTECT OUR ENVIRONMENT
Electrical products must not be thrown out with domestic waste. Recycle them at
the special disposal centers provided for the purpose. Contact your local authorities
or stockiest for advice on recycling.
The potential e ects on the environment and human health as a result of the
presence of hazardous substances in electrical and electronic equipment.
For disposal, this tool also can be returned to the hardware store or vendor (or
Dexter Power dealer).
Solution
Connect to power
supply
Check by a specialist
electrician.
Check by a specialist
electrician
Use a proper
extension cord
Connect to another
power source
Clean the air vents
Replace with a new
one
Use suitable sanding
paper
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
EN
177
Publicidad
