HQ-Power VDP130RGBLD11 Manual Del Usuario página 4

3. Installation
a) Fuse
• Only fit or replace a fuse when the device is unplugged from the mains.
• Replace a blown fuse with a fuse of the same type and rating (see "Technical Specifications"):
1. Remove the fuse holder using a flat-head screwdriver.
2. Remove the old fuse and install a new one.
3. Replace the fuse holder.
b) Mounting the Device
• Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable norms.
• The carrying construction must be able to support 10 times the weight of the device for 1 hour without deforming.
• The installation must always be secured with a secondary attachment e.g. a safety cable.
• Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified technician
check the device once a year and once before you bring it into service.
• Install the device out of reach of unauthorized persons, i.e. at a minimum height of 2.5m, in a location with few
passers-by.
• Overhead mounting requires extensive experience: calculating workload limits, determining the installation
material to be used... Have the material and the device itself checked regularly. Do not attempt to install the
device yourself if you lack these qualifications as improper installation may result in injuries.
• Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
• Make sure there is no flammable material within a 0.5m radius of the device.
• Respect a minimum distance of 0.5m between the device's light output and any illuminated surface.
• Do not place any object within a distance of 0.5m of the projector's fan and air vents.
• Avoid illuminating the projector.
• Have a qualified electrician carry out the electric connection.
• Connect the device to the mains with the power plug. Do not connect it to a dimming pack.
• The installation has to be approved by an expert before the device is taken into service.
4. Description
1. X adjustment
2. Y adjustment
3. R adjustment
4. G adjustment
5. B adjustment
6. sound sensitivity
7. DIP switches
8. DB25 connector
9. DMX out
10. DMX in
11. interlock
12. key switch
13. power on/off
14. power socket
15. ILDA connector
VDP130RGBLD11
4 HQPOWER