Lithium­iOn Battery Status Display; Technical Data - Hilti TE 500-A36 Manual De Usario

3.3 Active Vibration Reduction
The tool is equipped with an Active Vibration Reduction (AVR) system which reduces vibration noticeably.
3.4 Service indicator
The product is equipped with a service indicator LED.
3.4.1 MMI
Status
The Service indicator lights up.
The Service indicator flashes.
The ON/OFF indicator lights up.
The ON/OFF indicator flashes.
The ON/OFF indicator is off.
The Half power indicator lights up.
The Half power indicator is off.
3.4.2 Lithium­ion battery status display
The Li-ion battery state of charge and malfunctions of the power tool are indicated by the display on the Li­ion
battery. The Li­ion battery state of charge is displayed after pressing one of the two battery release buttons.
Status
4 LEDs light.
3 LEDs light.
2 LEDs light.
1 LED lights.
1 LED blinks.
1 LED flashes, the product is not in working order.
4 LEDs flash, the product is not in working order.
Battery state of charge cannot be displayed while the control switch is pressed and for up to 5 seconds
after releasing the control switch.
If the battery display LEDs blink, please observe the instructions given in the Troubleshooting section.
3.5 Items supplied
Breaker, side handle, operating instructions.
Other system products approved for use with this product can be found at your local Hilti Store or online at:
www.hilti.group.
4

Technical data

Rated voltage
Weight in accordance with EPTA procedure 01
Chuck
Storage temperature
Ambient temperature for operation
4.1 Noise information and vibration values in accordance with EN 60745
The sound pressure and vibration values given in these instructions were measured in accordance with a
standardized test and can be used to compare one power tool with another. They can also be used for a
18 English
Printed: 16.07.2019 | Doc-Nr: PUB / 5503655 / 000 / 00
Meaning
Servicing is due.
Have the product repaired by Hilti Service.
The product is switched on
The product is switched off because of a transient
fault.
The product is switched off.
The product is working at half power.
The product is working at full power.
Meaning
State of charge: 75 % to 100 %
State of charge: 50 % to 75 %
State of charge: 25 % to 50 %
State of charge: 10 % to 25 %
State of charge: < 10 %
The battery has overheated or is completely dis-
charged.
The power tool is overloaded or has overheated.
2240495
*2240495*
TE 500-A36
36 V
7.9 kg
TE­Y
−20 ℃ ... 70 ℃
−17 ℃ ... 60 ℃