JB Systems DynaSpot Manual De Instrucciones página 9

ENGLISH
OFFSET MENU:
Used to adjust the home position of several functions: offset parameters for PAN, TILT, COLORS and
GOBOS.
Make sure that the unit is connected to a DMX-controller and set to 10CH channel mode: set ch6 + ch7 to
maximum.
If you're not already in the setup menu, just press the MODE button shortly to
enter the setup menu.
 Now press the ENTER button for at least 5 seconds to go into offset mode.
 Use DOWN and UP buttons to select the function that you want to adjust
 Press the ENTER button.
 Use DOWN and UP buttons to adjust the home position
 Press the ENTER button to select your setting.
 Press the MODE button for about 2 seconds to store the setting and to return to running mode.
ELECTRICAL INSTALLATION + ADDRESSING
Important: The electrical installation should be carried out by qualified personal only,
according to the regulations for electrical and mechanical safety in your country.
Electrical installation for 1 standalone unit:
 Just insert the mains cable. The unit starts working immediately in stand-alone mode.
Remark1: You can use the included infrared remote controller if you want to have more control. Refer to
"OPERATE THE UNIT BY INFRARED REMOTE" to learn how to do this.
Remark2: if there's no output, please make sure to set the blackout mode [BLMd] of the projector to
"SOUN" and sound sensitivity [SOSE] to a value over 50 (see previous chapter).
Electrical installation for two or more units in master/slave:
In this mode the units will show a synchronized show, working to the rhythm of the beat.
 Connect 2 to maximum 16 units together using good quality balanced microphone cables. The first unit
in the chain will automatically act as the master, the other units will act automatically as slaves.
 Make sure that all units are connected to the mains.
 Done!
Remark1: You can use the included infrared remote controller if you want to have more control. Refer to
"OPERATE THE UNIT BY INFRARED REMOTE" to learn how to do this.
Remark2: if there's no output, please make sure to set the blackout mode [BLMd] of the MASTER
projector to "SOUN" and sound sensitivity [SOSE] to a value over 50 (see previous chapter).
Electrical installation for two or more units in DMX-master/slave:
In this mode the units will show a synchronized show, working to the rhythm of the beat but you can still
control some functions on the master by 1 or 5 DMX-channels.
 To assure proper operation you need an optional "Mini DMX-SPLITTER" to isolate the master/slave line
from the main DMX-line, see drawing.
 Connect 2 to maximum 16 units together using good quality balanced microphone cables. The first unit
in the chain will act as the master, the other units will act automatically as slaves.
JB SYSTEMS
®
7/59
USER MANUAL
DYNASPOT