Appliance Description; Operating Mode; Exhaust-Air Mode; Before Using For The First Time - Bosch DKE 995 F Instrucciones De Manejo

Appliance description

Glass panel
Lighting

Operating mode

Exhaust-air mode:

❑ The extractor-hood fan extracts the
kitchen vapours and conveys them
through the grease filter into the
atmosphere.
❑ The grease filter absorbs the solid
particles in the kitchen vapours.
❑ The kitchen is kept almost free of grease
and odours.
D
If the extractor hood is in exhaust-air
mode and a flue-type heater is running
at the same time (e.g. gas, oil or solid-fuel
heaters, continuous-flow heaters, water
heaters), ensure that the fireplace has an
adequate air supply for combustion.
Safe operation requires that the low air
pressure in the room in which the fireplace
is located does not exceed 4 Pa (0.04
mbar).
8
Chimney panelling
Light / fan
switches
Filter grille
Operating mode
This low air pressure can be obtained,
provided combustion air can escape
through non-lockable openings, e.g. in
doors, windows, air-intake/exhaust-air wall
boxes or by other technical procedures,
such as reciprocal interlocking, etc.
An air-intake/exhaust-air wall box by itself is
no guarantee that the limiting value will not
be exceeded.
Note: When assessing the air pressure, the
entire ventilation system in the house/apart-
ment must be taken into account. If using
cooking appliances, e.g. hob and/or gas
cooker, this rule does not apply.
Government regulations must be observed
for the conveyance of exhaust air.
Before using for the first time
Important notes:
This extractor hood complies with all
relevant safety regulations.
Repairs should only be carried out by
qualified specialists.
Improperly executed repairs can give
rise to significant hazards for the user.
The appliance is not intended for use
by young children or infirmed persons
without supervision.
Young children should be supervised to
ensure they do not play with the appliance.
The appliance should only be
connected up to the mains and taken into
use by a qualified specialist.
Dispose of packaging materials
properly (see Installation instructions).
Light bulbs must always be fitted when
the extractor hood is in use.
Defective bulbs should be replaced
immediately to prevent the remaining bulbs
from overloading.