Preparation Of The Dishes; Selecting The Wash Cycle; Thermo-Stop (Only B, C Mod.); Stopping The Wash Cycle And End Of Wash Cycle - Virtus Evo Generation Instrucciones De Instalación, Uso Y Mantenimiento

EN

5.1.5 Preparation of the dishes

Before washing the dishes, the preparatory steps below should be followed:

Remove the largest pieces of waste from the dishes before placing them in the baskets.

Wash glassware first.

Put the plates in the rack basket.

Place the glasses upside down.

Place the cutlery in the cutlery baskets with the handles downwards. The different pieces of
cutlery can be mixed.

Place the cutlery baskets in the lower baskets.

5.1.6 Selecting the wash cycle

Before starting the wash cycle, place the corresponding basket containing the dishes in the machine
and close the door. A wash cycle must be selected in order to start the wash in the A, B models.
Each wash cycle corresponds to a wash time that should be selected according to the user
requirements (60 s/90 s-120 s/180 s). Then press START and the wash cycle will start automatically.
In the C models, to start the wash process, select the wash cycle you wish to run by pressing button
O Programme selector switch. Each wash cycle corresponds to a wash time that should be selected
according to the user requirements (60 s/90 s/180 s/90 s). Then press button Q START cycle button
The door must be closed for the machine to start the wash cycle. For safety reasons,
if the door is open, the wash cycle will not start.

5.1.7 Thermo-stop (only B, C MOD.)

The thermo-stop is designed to ensure a constant rinse at the maximum temperature. This means
that the machine continues washing until the boiler reaches the ideal temperature. Then the rinse
cycle starts.
If the mains water temperature is less than 50 ⁰C / 122 ⁰F, the installation of this
system may reduce the wash capacity of the glass washer.

5.1.8 Stopping the wash cycle and end of wash cycle

The wash cycle can be stopped in the following ways:

By switching off the machine → the cycle stops completely.

By opening the door → when the door is closed, the cycle continues.
At the end of the wash cycle, remove the basket and leave the dishes to dry naturally. Remove the
dishes from the basket with clean hands, taking care not to burn yourself as the dishes are extremely
hot.

5.1.9 Cold rinse (only COLD versions)

The COLD versions have a cold rinse programme. To run this programme, keep the cycle selector
switch set to cold rinse (M) for the required time. While the switch is held in this position, the machine
will run a rinse using cold water from the mains supply.

5.1.10 Drainage of the machine

The dishwashers have two types of drainage; gravity drainage or using a drainage pump.
5.1.10.1 Drainage by gravity
To drain the machine in this way, just remove the overflow from the machine and it will drain
naturally. For reasons of safety, this method of drainage should only be used with the machine
switched off.
42
During the first heating of the day, the boiler may reach a higher temperature than
that mentioned above due to heating inertia. This is normal. If pressurised steam is
observed coming out of the rinse branch nozzles, while the boiler is heating, the
technical service should be notified.