Cleaning; Storage; Troubleshooting - ProCharger CP-10 Instrucciones De Montaje Y De Uso

7 | Cleaning

NOTE!
Risk of short circuit!
Water or other liquids which have penetrated into the housing can
cause a short circuit.
• Never immerse the battery pack in water or other liquids.
• Make sure that no water or any other liquids are allowed to enter
into the housing.
− gelangen.
NOTE!
Risk of damage!
Improper handling of the battery pack can lead to damage of the
battery pack.
• Do not use aggressive cleaning agents, brushes with metal or
nylon bristles, or sharp or metallic cleaning objects such as
knives, hard spatulas or similar. These can damage the surfaces.
1. Before cleaning, disconnect the battery pack from the power supply.
2. Allow the battery pack to cool down fully.
3. Wipe off the battery pack with a slightly dampened cloth. Then wipe all parts so
that they are completely dry.

8 | Storage

Store the battery pack and the accessories in the storage bag 14 at a temperature of
between -10°C and +60°C and relative air humidity of 0-99% (non-condensing).

9 | Troubleshooting

In the event of a fault occuring, try to resolve it with the following measures first of
all:
30
Fault Possible causes and remedy
The battery pack does not The internal rechargeable battery is
switch on, the LED lamp 6 discharged.
does not work and devices
− Charge the rechargeable battery
cannot be charged.
The battery pack is not connected
It is not possible to perform a
correctly.
jump start.
− Check the connection with the
− The battery pack is not fully charged
− The device does not reach its full
− The current consumption or starting
− The charging cable is overloaded
The charging cable beeps
− Disconnect the cables from the
completely.
vehicle. All the contact points
must be clean and the battery
clip cable 9 must be connected
correctly.
jump start capacity until it has been
discharged/charged three times.
of the vehicle is too high
battery pack and the battery
terminals
31