Installation Types; Enclosed Installation; Free-Standing Installation; Built-In Installation - Orien FS-260IM Manual Del Usuario

IMPORTANT:
1. All installations must be in accordance with local plumbing code requirements.
Professional installation is recommended.
2. Water inlet fitting: 3/8" FPT (Female Pipe Thread); drain line connection: 1/2" FPT.
3. Make certain you have a suitable water supply hose and two suitable drain hoses, and that
the hoses are not pinched, kinked or damaged during installation.
4. Check for leaks after connection.
Tools required: 3/8" open-end wrench, Phillips screwdriver
Connecting the water line:
1. Turn off main water supply.
2. Find a water supply line near the installation location. The distance should be less than the
length of the water supply hose.
3. A shut-off valve must be installed to the main water supply.
4. Connect the water supply hose to tap and water inlet valve. Tighten firmly by hand, then
one-half turn with wrench.
5. Connect one water drain hose to ice maker drain line connection. Tighten firmly by hand,
then one-half turn with wrench.
6. Connect another water drain hose to bin drain line connection. Tighten firmly by hand, then
one-half turn with wrench.
7. Turn on main water supply and tap. Check for water supply connection leaks. Tighten every
connection (including connections at the water inlet).
NOTE: If using a water filter, be sure to follow the filter manufacturer's directions.

Installation Types

This ice cube machine has been designed to be enclosed (as under a cabinet). It can also be free-
standing (using the supplied stability brackets) or built-in (sealed to the floor). In every case,
there must be adequate air space around the unit for ventilation purposes (see diagrams on page 8).

Enclosed Installation:

An enclosed installation will allow you to install the ice cube machine under a counter or in a
kitchen cabinet provided the required clearance space around the ice maker is respected. You
must follow the stated instructions for
a. Electrical requirements
b. Water supply

Free-standing Installation:

The ice cube machine can be installed to be free-standing in any place you desire provided you
have access to a water supply. This installation has the same requirements as an enclosed
installation, plus you must also follow the stated instructions for Installing the Stability Brackets.

Built-in Installation:

If this method of installation is chosen, it will still be necessary to allow adequate ventilation
space around the unit. The following additional items must be observed.
1. Place the ice cube machine in front of the installation location. Raise the machine and place it
on the floor or on a platform depending on your installation requirements.
2. The water supply line must be plumbed before connecting to the ice maker.
3. Turn on the main water supply and tap. Check for water supply connection leaks. Tighten
every connection (including connections at the water inlet).
4. If the electrical outlet for the ice maker is behind the cabinet, plug in the ice maker.
5. Push the ice maker into position.
6. Seal all around the cabinet to the floor with an approved caulking compound.
11